Experimental Study of Artificial Lightning Generator Using Van be Graaf type D.C.High Voltage
| Project/Area Number |
06555083
|
|---|
| Research Category |
Grant-in-Aid for Developmental Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Research Field |
電力工学・電気機器工学
|
|---|
| Research Institution | Toyota National college of Technology |
|---|
Principal Investigator |
KAJITA Shogo (1995) Toyota National college of Technology, Department of Electrical Engineering, Professor, 電気工学科, 教授 (40043195)
堀井 憲爾 (1994) 豊田工業高等専門学校, 校長 (70023223)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
NAKANO Minoru Toyota National college of Technology, Department of Information and Computer En, 情報工学科, 教授 (50023685)
USHIRODA Sumio Toyota National college of Technology, Department of Electrical Engineering, Pro, 電気工学科, 教授 (80043214)
KOMORI Katuo Toyota National college of Technology, Department of Mechanical Engineering, Pro, 機械工学科, 教授 (90043190)
梶田 省吾 豊田工業高等専門学校, 電気工学科, 教授 (40043195)
|
|---|
| Project Period (FY) |
1994 – 1995
|
| Project Status |
Completed (Fiscal Year 1995)
|
| Budget Amount *help |
¥3,700,000 (Direct Cost: ¥3,700,000)
Fiscal Year 1995: ¥1,200,000 (Direct Cost: ¥1,200,000)
Fiscal Year 1994: ¥2,500,000 (Direct Cost: ¥2,500,000)
|
|---|
| Keywords | Artificial Lightning Generator / Hot balloon / Corona Discharge / Charging Voltage / Electrical Charge / Charge Transfer / Van de Graaf |
|---|
| Research Abstract |
Following the preliminary test of Van de Graaf type DC high voltage generator in the last year, the test has progressed on the ballon of 6m diameter, fastened to the stage in high of 4 m on ground, and charged up to about 1 MV under the effect of wind. The test were carried out as follows ; (1) As a preliminary for ground test, the charging test on polyethylene tube of 0.23 m diameter with 0.1mm thickness was carried out in laboratory. The ring wire electrode charged to positive voltage to plane electrode grounded was developed to make a positive corona discharge at the wire electrode. The charge density on the tube surface was measured with a field-mill meter as 3.8 mu C/m at the charging voltage 14.7KV on the wire. (2) The high voltage generator for the artificial lightning discharge was constructed on the ground of our college. The stage for fastening the ballon of 6 m diameter was supported with four tubes of 4 m length and 8 cm dia-meter of polyvinyl-chloride in the insulated condition from ground. The balloon was successfully blew up on the stage by heating with propane gas burners. The roller of 1 m diameter on the stage and the other two rollers on ground were rotated to transfer the charge deposited on the poly-ethylene tube surface moved with rollers. The surface charge was successfully transferred to the balloon up to the high voltage, then the charge was discharged to ground with a spark-over.
After the experiment of 5 MV charging with 16 m diameter ballon, the prospect of the experiment of 50MV charging with 80 m diameter balloon in the future will be given.
|
Report
(3 results)
Research Products
(3 results)
