| Project/Area Number |
11650183
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Fluid engineering
|
|---|
| Research Institution | Kagoshima University |
|---|
Principal Investigator |
NOZAKI Tsutomu Faculty of Engineering, Kagoshima University Professor, 工学部, 教授 (50041546)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
LI Hui Faculty of Engineering, Kagoshima University Research Associate, 工学部, 助手 (00253906)
FUKUHARA Minoru Faculty of Engineering, Kagoshima University Associate Professor, 工学部, 助教授 (20189971)
|
|---|
| Project Period (FY) |
1999 – 2000
|
| Project Status |
Completed (Fiscal Year 2000)
|
| Budget Amount *help |
¥3,700,000 (Direct Cost: ¥3,700,000)
Fiscal Year 2000: ¥300,000 (Direct Cost: ¥300,000)
Fiscal Year 1999: ¥3,400,000 (Direct Cost: ¥3,400,000)
|
|---|
| Keywords | Flow control / Jet / Particle Image Velocimetry / Diffusion / Turbulent flow / Impinging jet / Heat transfer / Heat transfer enhancement |
|---|
| Research Abstract |
(1) As a fundamental experiment on a doublet flow, the effects of injection velocity and the ratio of injection to suction on the flow were investigated. By using the PIV, the mean value of fluctuating velocity was found from its time mean value in the measuring section and the predicted equation is proposed by the velocity ratio and the diameter ratio. These are obtained from the conditions at the constant injection velocity and diameter. It was found that there exists a similarity of the flow at the same velocity ratio and the diameter ratio.
(2) As an advanced experiment, the improvement of heat transfer and the reduction suction flow rate are investigated. For the former, it was clarified that the increase of the fluctuating velocity obtained by the fundamental experiment contributes to the heat transfer. From the results of the coefficient of heat transfer measured, the effectiveness of the doublet flow is confirmed. For the later, in order to reduce the suction flow, it is proposed to attach the suction pipe made longer. By making the suction pipe longer, it was clarified the above mentioned reduced suction flow can be obtained.
|
