| Project/Area Number |
14550279
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
電力工学・電気機器工学
|
|---|
| Research Institution | TOKYO POLYTECHNIC UNIVERSITY |
|---|
Principal Investigator |
MATSUI Mikihiko MATSUI,Mikihiko, 工学部, 教授 (30143689)
|
|---|
| Project Period (FY) |
2002 – 2003
|
| Project Status |
Completed (Fiscal Year 2003)
|
| Budget Amount *help |
¥4,100,000 (Direct Cost: ¥4,100,000)
Fiscal Year 2003: ¥1,300,000 (Direct Cost: ¥1,300,000)
Fiscal Year 2002: ¥2,800,000 (Direct Cost: ¥2,800,000)
|
|---|
| Keywords | Wind turbine generator system / Sensor-less / Maximum power point tracking (MPPT) / Limit cycle / Flywheel / Power leveling / Autonomous distributed power supply system / Wind turbine generator simulator |
|---|
| Research Abstract |
In 2003,the last year for this project, the following points have been investigated in order to accelerate the diffusion of wind turbine generation systems, and some excellent results have been obtained ;
A. MPPT operation of small sized wind turbine generators
i) Performance evaluation of a 50W output wind turbine generator has been carried out following that in 2002. This year, the large scale wind tunnel in Tokyo Plytechnic University Wind Engineering Center has been utilized for the testing. The comparative study of performance under idealized uniform wind speed and that under using a blower has been investigated in detail. It turned out that the performance characteristics can be sufficiently reproduced by the testing using a small blower, which enables easy testing with in -door conditions.
ii) It has been shown that the "Limit cycle MPPT control scheme" which has been developed for a photovoltaic system is also applicable to the wind turbine generation system. Which enables a power
… More
sensor-less and rotating speed sensor-less MPPT control system for a wind turbine generation system.
iii) The current control loop of the real-simulator system using a 2.2kW induction motor and a 2kW PM synchronous generator has been improved by replacing hysterisis comparator with d-q frame based controller.
B. Power leveling of fluctuated power using flywheel
A control scheme for rotating speed picking-up and constant power acceleration of a flywheel energy storage system, which is one of the important techniques in utilizing flywheels, has been investigated.
C. Extraction of the problems in small sized autonomous distributed power supply systems
Stability study of equivalent resistance control for an autonomously controlled distributed power supply system has been investigated by calculating the system eigen values. It turned out that the equivalent resistance control which is adopted to stabilize the dc link voltage in steady state condition is not effective for dumping the transient response of the system. This fact is informative for the future investigation on the control strategies. Less
|
