Plastic bending of adhesively bonded dissimilar sheet metals using temperature and rate-dependent highly ductile
| Project/Area Number |
18560123
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Production engineering/Processing studies
|
|---|
| Research Institution | Hiroshima National College of Maritime Technology |
|---|
Principal Investigator |
TAKIGUCHI Michihiro Hiroshima National College of Maritime Technology, Department of Maritime Technology, Professor (10163346)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
YOSHIDA Tetsuya Hiroshima National College of Maritime Technology, Department of Electronic Control Engineering, Professor (20182769)
FUNAKI Mitsuo Hiroshima National College of Maritime Technology, General Arts, Professor (90209148)
|
|---|
| Project Period (FY) |
2006 – 2007
|
| Project Status |
Completed (Fiscal Year 2007)
|
| Budget Amount *help |
¥2,940,000 (Direct Cost: ¥2,700,000、Indirect Cost: ¥240,000)
Fiscal Year 2007: ¥1,040,000 (Direct Cost: ¥800,000、Indirect Cost: ¥240,000)
Fiscal Year 2006: ¥1,900,000 (Direct Cost: ¥1,900,000)
|
|---|
| Keywords | Structural adhesion / Plastic Forming / Multi-axial elasto-visconlasticity constitutive model / Temperature-dependent / Rate-dependent |
|---|
| Research Abstract |
We have recently proposed a new technique of plastic forming of adhesively bonded sheet metals, where two flat sheets, which are the same materials, are adhesively bonded together and then press-formed, which are completely different from the conventional process of adhesive joint. In this technique, suppression of large transverse shear deformation occurring in the adhesive layer during bending is of vital importance, since it would cause the geometrical imperfection of bent sheets (so-called gull-wing bend).
In this study, the effects of material characteristics on plastic forming of adhesively bonded dissimilar sheet metals were investigate by experiments and finite element method (FEM) analysis. The analysis considered as two-dimensional plane strain problem. In addition, adhesive characteristics were determined by using the Table function of Marc2005.
The main conclusions are summarized as follows:
(1) A multi-axial elasto-viscoplasticity constitutive model of temperature- and rate-dependent of the adhesive is presented.
(2) In the adhesively bonded dissimilar sheet metals, the shear deformation and gull-wing bend are suppressed by the combination of the sheet metals, when a bending inside sheet has high-tensile strength while a bending outside sheet has low-tensile strength.
(3) When the thickness of the adherends increases, the shear deformation and gull-wing bend becomes larger, which in some cases lead to the delamination.
(4) Numerical simulation of air-bending (three-point bending) was performed using Marc2005. The correspondence of calculated results to experimental ones is relatively good.
|
Report
(3 results)
Research Products
(31 results)
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
[Presentation] 異種金属接着板の塑性曲げ加工2008
Author(s)
瀧口 三千弘
Organizer
日本接着学会第46回年次大会
Place of Presentation
関西大学100周年記念会館
Year and Date
2008-06-27
Description
「研究成果報告書概要(和文)」より
Related Report
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
