RC構造物の補強に用いるPCM-コンクリート界面の革新的接着工法
| Project/Area Number |
20J20854
|
|---|
| Research Category |
Grant-in-Aid for JSPS Fellows
|
| Allocation Type | Single-year Grants |
|---|
| Section | 国内 |
|---|
| Review Section |
Basic Section 22010:Civil engineering material, execution and construction management-related
|
|---|
| Research Institution | Hokkaido University |
|---|
Principal Investigator |
Mizan Mahmudul Hasan 北海道大学, 大学院工学院, 特別研究員(DC1)
|
|---|
| Project Period (FY) |
2020-04-24 – 2023-03-31
|
| Project Status |
Completed (Fiscal Year 2022)
|
| Budget Amount *help |
¥3,100,000 (Direct Cost: ¥3,100,000)
Fiscal Year 2022: ¥1,000,000 (Direct Cost: ¥1,000,000)
Fiscal Year 2021: ¥1,000,000 (Direct Cost: ¥1,000,000)
Fiscal Year 2020: ¥1,100,000 (Direct Cost: ¥1,100,000)
|
|---|
| Keywords | Polymer cement mortar / overlaying method / Interfacial strength / premature debonding / interfacial strength / silica fume |
|---|
| Outline of Research at the Start |
Recently, PCM overlaying method is gaining popularity world-wide as a repair material though debonding issue at concrete-PCM interface hinder the worldwide application of this strengthening method. Also, instead of reliable design method of this technique, there are only recommendations relying on the experience and very crude design proposals. Concerning this issue, a lot of experimental and analytical work will carry out in three years based on either engineering viewpoints to improve the bonding quality of the interface or analytical viewpoints to clarify the interfacial bond mechanisms.
|
| Outline of Annual Research Achievements |
From the perspective of practical application of PCM overlaying method, long-term performance of composite specimens was evaluated under severe environmental conditions. The quantitative measurement of interfacial shear and tensile strength of the composite specimen with and without silica fume was done considering environmental conditions; elevated temperature, moisture and freeze-thaw cycle. After preparation of the composite specimen, sufficient curing and corresponding exposure conditions, tests (splitting tensile and shear test) was performed with autograph to evaluate interfacial bond strength between concrete and PCM under particular condition. In addition, four-point bending tests of strengthened RC beam with and without silica fume as repaired material was conducted to resemble material level test with the aim to use silica fume in practical PCM strengthening technique. Three type of strengthening material: reinforcement, CFRP grid and CFRP strand sheet was used as a strengthening bar. Strain gauges was attached to the strengthening and the main reinforcement to get strain distribution. The performance of PCM strengthened RC beams using particular strengthening bars with or without silica fume were compared under different heads, viz. failure modes, load deflection relationship, ultimate load, debonding load and, strain value and strain distribution of the strengthening bar along the beam. The ultimate load of strengthened beams considering perfect bond between substrate concrete-overlay material were also calculated and compared with the experiment results.
|
| Research Progress Status |
令和4年度が最終年度であるため、記入しない。
|
| Strategy for Future Research Activity |
令和4年度が最終年度であるため、記入しない。
|
Report
(3 results)
Research Products
(5 results)
