| Project/Area Number |
20K05169
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Multi-year Fund |
|---|
| Section | 一般 |
|---|
| Review Section |
Basic Section 26050:Material processing and microstructure control-related
|
|---|
| Research Institution | Osaka University |
|---|
Principal Investigator |
劉 恢弘 大阪大学, 接合科学研究所, 准教授 (40748943)
|
|---|
| Project Period (FY) |
2020-04-01 – 2022-03-31
|
| Project Status |
Discontinued (Fiscal Year 2021)
|
| Budget Amount *help |
¥4,290,000 (Direct Cost: ¥3,300,000、Indirect Cost: ¥990,000)
Fiscal Year 2022: ¥1,040,000 (Direct Cost: ¥800,000、Indirect Cost: ¥240,000)
Fiscal Year 2021: ¥1,040,000 (Direct Cost: ¥800,000、Indirect Cost: ¥240,000)
Fiscal Year 2020: ¥2,210,000 (Direct Cost: ¥1,700,000、Indirect Cost: ¥510,000)
|
|---|
| Keywords | Friction welding / Titanium alloy / Stainless steel / Ultralow rotation speed / High friction pressure / Microstructure / Mechanical properties / Microstructural / Welding principle / Spinal fixation surgery |
|---|
| Outline of Research at the Start |
In this study, how the welding parameters physically affect thermal cycle and strain/strain-rate during friction welding (FW), hence affecting weld interface microstructure and joint mechanical properties, i.e. the welding principle for FW of titanium alloy/stainless steel is first time quantitatively clarified via experimental and simulation analysis. Sound Ti-6Al-4V/SUS316L/Ti-6Al-4V joints are thus fabricated to better serve spinal fixation surgery.This study might also provide a guide for FW of other dissimilar combinations for wider applications.
|
| Outline of Annual Research Achievements |
In the last step, we have found that high shear strain rate between two materials and high temperature rising rate would cause the formation of harmful mechanically mixed layers during friction welding (FW) of Ti-6Al-4V (Ti64) and SUS316L, hence significantly deteriorating the joint quality. Rotation speed reduction (to 100 rpm) and liquid CO2 cooling were then adopted to reduce the shear strain rate and temperature rising rate. As a result, the mechanically mixed layer formation was effectively suppressed, and the joint quality was successfully improved.
Based on these findings, an ultralow rotation speed with a proper high friction pressure were adopted in this step in order to eliminate the liquid CO2 cooling process. The ultralow rotation speed of 40 rpm provided a low temperature rising rate and a low peripheral velocity corresponding to a low shear strain rate between faying surfaces, hence suppressing the formation of harmful mechanically mixed layers and associated cracks. The proper high friction pressure of 450 MPa produced a proper welding temperature that produced a thin and strong intermetallic compound layer while avoiding interface cracking. Furthermore, the proper high friction pressure worked to guarantee a sufficient faying surface deformation on SUS316L to sufficiently reduce surface roughness, break oxide layers and create fresh surfaces. Finally, a Ti64/SUS316L FW joint with superior quality was successfully fabricated in a simpler way using ultralow rotation speed and proper high friction pressure, without using liquid CO2 cooling.
|
