1994 Fiscal Year Final Research Report Summary
STUDIES ON SIMULATION AND CONTROL OF TRUCK CRANES IN SWING MOTION
| Project/Area Number |
05452166
|
|---|
| Research Category |
Grant-in-Aid for General Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Research Field |
Dynamics/Control
|
|---|
| Research Institution | UNIVERSITY OF TOKUSHIMA |
|---|
Principal Investigator |
YOSHIMURA Toshio UNIV.OF TOKUSHIMA,FACULTY OF ENGRG.PROFESSOR, 工学部, 教授 (90035618)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
HINO Junichi UNIV.OF TOKUSHIMA,FACULTY OF ENGRG.ASSOCIATE PROFESSOR, 工学部, 助教授 (10173189)
KONISHI Katsunobu UNIV.OF TOKUSHIMA,FACULTY OF ENGRG.PROFESSOR, 工学部, 教授 (20035653)
|
|---|
| Project Period (FY) |
1993 – 1994
|
| Keywords | TRUCK CRANE / SWING CONTROL / FUZZY CONTROL / SIMULATION / HYDRAULIC SYSTEM / BOOM / SUSPENDED LOAD / MODELLING |
|---|
| Research Abstract |
1.The swing control of hydraulic truck cranes requires to operate a suspended load to the desired position without vibration, but the operation is so difficult. Therefore, the swing control becomes so effective if the dynamic behavior of the cranes containing the hydraulic system is accurately modelled. Firstly, the dynamic behavior of the cranes in swing operation is modelled, in which the booms are approximately expressed as lumped-mass systems, and the mechanical system is combined with the hydraulic system. The dynamic behavior of the cranes is simulated and is compared with experimental results. Secondly, the dynamic behavior of the cranes in elevating operation is modelled, in which the mechanical system is combined with the hydraulic system as well as the swing operation. The dynamic behavior of the cranes in elevating operation is simulated and is compared with experimental one.
The velocity control of the cranes in swing operation is presented. The velocity control of the swing
… More
motor in the hydraulic system and sway control in the pendulum-type system becomes necessary to control the suspended load. The velocity pattern to reduce the load sway in swing operation is determined for the control of the swing motor. The velocity of the swing motor is controlled to follow the velocity pattern by the proposed velocity-type fuzzy controller, velocity-type linear controller and feedforward fuzzy controller. By using such controllers, the dynamic behavior of the cranes in swing operation is simulated and its effectiveness is shown by comparing it with experimental one. Secondly, the velocity control of the swing motor in the hydraulic system and sway control in the pendulum-type system is presented. The approach to use the velocity pattern determined by the phase-trajectory and Newton-Raphson methods is adopted. The comparison of simulated and experimental results indicates that the sway is reduced by modifying the velocity pattern if the initial load sway is in the rotational direction. Less
|
Research Products
(8 results)
