1996 Fiscal Year Final Research Report Summary
APPLICATION OF THE STRESS MEASURING METHOD BY X-RAY IN ESTIMATION OF THE RESIDUAL STRESS FOR WELDED STRUCTURAL MEMBERS
| Project/Area Number |
07555311
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 試験 |
|---|
| Research Field |
船舶工学
|
|---|
| Research Institution | HIROSHIMA UNIVERSITY |
|---|
Principal Investigator |
IWATA Mitsumasa HIROSHIMA UNIVERSITY GRADUATE SCHOOL,INTERNATIONAL DEVELOPMENT AND COOPERATION,PROFESSOR, 大学院・国際協力研究科, 教授 (80034346)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
YAJIMA Hiroshi HIROSHIMA UNIVERSITY FACULTY OF ENGINEERING,PROFESSOR, 工学部, 教授 (40263727)
HUANG Yi HIROSHIMA UNIVERSITY FACULTY OF ENGINEERING,ASSOCIATE PROFESSOR, 工学部, 助教授 (20253114)
|
|---|
| Project Period (FY) |
1995 – 1996
|
| Keywords | Welded structures / Restraint welding joints / Residual stress / Restraint force / Non-fracture measurement / X-ray stress analysis / Inverse analysis for restraint force / FEM analysis |
|---|
| Research Abstract |
For all kinds of welding joints with complex restrictions in real welded structures, stress measuring method X-ray can be applied to base metal, however, the accuracy can not be guaranteed when the X-ray method is applied to welding joints. That is, there is no a non-fracture measuring method with a satisfactory accuracy for the measurement of the welding residual stress distributing in real welded structures.
So that in this research, the measuring technique of residual stress by using X-ray stress measuring method for the base metal was established firstly, and then an estimating method for residual stress in the whole welded structure based on the measurement of the residual stress at base metal was investigated. The results may be summarized as follows.
1) The X-ray stress measuring equipment was fit up with An incidence angle operator. So that the X-ray stress measuring equipment can be remote controlled, and the bodily injury inflicted by X-ray can be prevented completely.
2) The applicability of the X-ray stress measuring equipment to real structures was confirmed with measurements of residual stress for many kinds of welded structural models by using sin^2psi methods and phi-sin^2psi method both of which are the X-ray stress analysis method, and at the same time the data base for the estimation of the residual stress in a whole welded structure by numerical analysis method has been set up.
3) A method that estimating the restraint stress of structural members and the inherent strain of welded joints so that estimating the welding residual stresses for the whole structure was developed. Affectivity and applicability of the developed method was shown by its applications to some big experiment models.
|
Research Products
(4 results)
