1998 Fiscal Year Final Research Report Summary
Experimental Study on the Effect of Partial Loss of Sectional Area on the Static Characteristics
| Project/Area Number |
08455244
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Building structures/materials
|
|---|
| Research Institution | Utsunomiya University |
|---|
Principal Investigator |
TANAKA Atsuo Professor, Department of Architecture Faulty Engineering Utsunomiya University, 工学部, 教授 (90197400)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
MASUDA Hiroshi 宇都宮大学, 工学部, 助手 (90238907)
IRIE Yasuyaka 宇都宮大学, 工学部, 助教授 (40114970)
|
|---|
| Project Period (FY) |
1996 – 1998
|
| Keywords | High Strengtn Bolt / Beam Joint / Partial Loss / H Shaped Beam / Deformation Capacity |
|---|
| Research Abstract |
In this paper, the effect of partial loss of sectional area at the flange of H-beams due to bolt holes on the statical characteristics were experimentally investigated in three test series. The test results show that such effect is estimated by considering not only the loss of sectional area of flange plates but also the reduction of plastic section modulus. When the rate of reduction of sectional area is smaller than 25%, such reduction of sectional area has small influence upon the statical characteristics of the beam. And it becomes clear that maximum strength and plastic deformation capacity decrease with increasing the rate of partial loss of sectional area, and that the reduction of maximum strength and plastic deformation capacity can be compensated by using high strength bolted friction joints at the part of bolt holes.
|
