1999 Fiscal Year Final Research Report Summary
RESEARCH AND DEVELOPMENT OF NEW FILLER MATERIALS FOR JOINING DIFFERENT MATERIALS BY ISOTHERMAL SOLIDIFICATION
| Project/Area Number |
09555227
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 展開研究 |
|---|
| Research Field |
Metal making engineering
|
|---|
| Research Institution | Kurume National College of Technology |
|---|
Principal Investigator |
SASAGURI Nobuya KURUME NATIONAL COLLEGE OF TECH., MAT. SCI. & MET. ENG., ASSOCIATE PROFESSOR, 材料工学科, 助教授 (50215737)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
HONDA Yoshioki KURUME NATIONAL COLLEGE OF TECH., MAT. SCI. & MET. ENG., ASSO. PROF., 材料工学科, 助教授 (10044281)
MATSUBARA Yasuhiro KURUME NATIONAL COLLEGE OF TECH., MAT. SCI. & MET. ENG., PROFESSOR, 材料工学科, 教授 (20044258)
|
|---|
| Project Period (FY) |
1997 – 1999
|
| Keywords | Cu-Mn alloy / Brazing / Isothermal solidification / Bond-strength / Ductile cast iron / High chromium cast iron / Ni-hard cast iron |
|---|
| Research Abstract |
For the purpose of developing a new filler metal with lower melting point and giving higher bond-strength, several kind of filler metals made of Cu-X alloys and Cu-X-Y alloys (X : Mn or Ag, Y : Fe, Cr or Al) were produced and applied to brazing of a ductile cast iron (DCI) and a mild steel. Irrespective of the kind of filler metal, alloyed phases precipitated at the DCI side and grew toward the steel side by isothermal solidification. In case of using Cu-25% Mn filler metal, a DCI and a steel could be joined at lower temperature of 1223K, and the same bond-strength (about 300 MPa) as brazed with pure copper could be obtained when the DCI and steel was brazed at the temperature (1300 K) lowered by about 80K compared with the usual temperature of copper brazing. When the Cu-25% Mn filler metal was applied to brazing of a high chromium cast iron and a steel, alloyed phases precipitated and the bond-strength showed about 220 MPa. In case of brazing of a Ni-hard cast iron and a steel at 1300K, the bond-strength of about 300 MPa was obtained. The effects of addition of third element to Cu-25% Mn filler metal was observed. Based on the above results, it can be said that the Cu-25% Mn alloy is a promising filler metal with lower melting point for joining cast iron and steel.
|
Research Products
(2 results)
