• Search Research Projects
  • Search Researchers
  • How to Use
  1. Back to project page

2001 Fiscal Year Final Research Report Summary

Identification of defects of wood by using wave analysis of tap tone and application to machine stress rating of lumber

Research Project

Project/Area Number 12660148
Research Category

Grant-in-Aid for Scientific Research (C)

Allocation TypeSingle-year Grants
Section一般
Research Field 林産学
Research InstitutionShizuoka University

Principal Investigator

SOBUE Nobuo  Shizuoka University, Faculty of Agriculture, Professor, 農学部, 教授 (50023495)

Co-Investigator(Kenkyū-buntansha) NAKAI Takahisa  Shimane University, Faculty of Science and Technology, Assistant Professor, 理工学部, 助手 (90314616)
HIRAI Nobuyuki  Shizuoka University, Faculty of Agriculture, Professor, 農学部, 教授 (70023439)
Project Period (FY) 2000 – 2001
KeywordsWood defects / Tap tone / Wave analysis / Identification of defets / Power spectrum / Logarithmic decrement / Stress rating
Research Abstract

Identification of defects in lumber by a wave analysis of tap tone and application to a machine stress rating of lumber were studied.
1. Identification of defects by a wave analysis.
A transfer matrix method was used to evaluate the spectrum peak shift due to defects of a specimen. A numerical equation which estimates the spectrum peak shift by defects was obtained. Experiments by using specimens having round holes showed the same tendency as the numerical simulation of the transfer matrix method. The peak shifts of the specimen having multiple holes were evaluated by a linear combination of the effect of individual hole. A new principle to identify the defects positions was proposed. The position was identified so that the coincidence between experimental and estimated values becomes maximum.
2. Determination of vibration parameters by a wave analysis
A tap tone includes useful information not only in a fundamental vibration but also in higher order vibration waves. Isolation of the wave of an individual mode was done by using the filtering procedure of Fourier transformation. Then Hilbert transformation was adopted to obtain a time envelope and logarithmic decrement was determined. Moreover, an instantaneous frequency given by Hilbert transformation showed a potential of a quasi time-frequency simultaneous analysis of a tap tone.
3. Application of wave information to machine stress rating of lumber
Small and full size wood specimens were used. A multiple regression analysis using Young's modulus, logarithmic decrement and irregularity in frequencies of higher ordered vibrations gave higher correlation than the case of a simple regression which used Young's moduli

URL: 

Published: 2003-09-17  

Information User Guide FAQ News Terms of Use Attribution of KAKENHI

Powered by NII kakenhi