2005 Fiscal Year Final Research Report Summary
Development of titanium denture plate with a new CAD/CAM system.
| Project/Area Number |
15592046
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
補綴理工系歯学
|
|---|
| Research Institution | Tokyo Medical and Dental University |
|---|
Principal Investigator |
MOTOMURA Kauo Tokyo Medical and Dental University, Graduate School, Research Associate, 大学院・医歯学総合研究科, 助手 (60272598)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
NAKAMURA Hideo Tokyo Medical and Dental University, Graduate School, Research Associate, 大学院・医歯学総合研究科, 助手 (60172425)
NAKAMURA Tamotsu Shizuoka Univ., Faculty of engineering, Professor, 工学部, 教授 (70023322)
TANAKA Shigekazu Shizuoka Univ., Faculty of engineering, Assistant Professor, 工学部, 助教授 (60197423)
|
|---|
| Project Period (FY) |
2003 – 2005
|
| Keywords | titanium / CAD / CAM / denture plate / Incremental forming / an aging society |
|---|
| Research Abstract |
A new flexible process for pure titanium denture plate using incremental forming technology is being developed. Denture plate is a important dental prosthetic component of complete denture. In this research, incremental sheet metal stretch forming was applied to fabrication of pure titanium denture plates. This process, however, posed difficult problems about poor seizure resistance. In order to improve the surface quality, anodic oxide film was tested. Although the oxide film showed good seizure resistance, reproducible sliding marks were produced in a certain region. The effect of the feed rate of forming stylus and the slope of surface on the roughness was investigated systematically. The excessive feed rate increased the roughness because of deep tool marks. The small feed rate increased the roughness due to the severe sliding contact with tool. The results confirmed the existence of optimum condition in which the roughness was minimized.
|
