2006 Fiscal Year Final Research Report Summary
Development of atmosphere controlled Tribotester and evaluation of tribological properties of hard thin films nanostructured with femtosecond laser
| Project/Area Number |
16360059
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Materials/Mechanics of materials
|
|---|
| Research Institution | Fukui National College of Technology |
|---|
Principal Investigator |
KOMAI Kenjiro Fukui National College of Technology, President, 校長 (70025948)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
YASUMARU Naoki Fukui National College of Technology, Mechanical Engineering, Professor, 機械工学科, 教授 (90158006)
KATO Hirotaka Fukui National College of Technology, Mechanical Engineering, Professor, 機械工学科, 教授 (30311020)
|
|---|
| Project Period (FY) |
2004 – 2006
|
| Keywords | femtosecond laser / ablation / hard thin film / DLC / nanostructure / scanning probe microscope / tribology |
|---|
| Research Abstract |
We report tribological properties of diamond-like carbon (DLC) film of which surface has been nanostructured with femtosecond (fs) laser pulses. A broad area on the DLC surface was nanostructured using a precise target-scan system developed for the fs-laser processing. In the present experiment we have developed two types of laser scan. One is a parallel scan to produce a uniformly nanostructured surface. The other is a crossed scan along a net-like pattern to form a partially nanostructured area on the surface. The results obtained are summarized as follows.
1)The nanostructure has been formed uniformly on the DLC surface over the area of 15 x 15 mm^2.
2)The structured surface at E = 110 μJ near the ablation threshold is uniformly modified to the GC layer.
3)The friction coefficient of the structured DLC film has shown a small decrease for the steel ball but a small increase for the ceramic WC-Co ball.
4)A large improvement of the friction coefficient of the DLC surface has been achieved by coating the MoS_2 layer on the nanostructured DLC surface. The measured friction coefficients μ of the surface were 0.07 with the steel ball and 0.02 - 0.04 with the WC-Co ball.
5)The net-like patterning of the ablated zone created by the crossed scan produces an effective method to increase μ, maintaining the initial surface flatness.
6)The nano-indentation test and nano-scratch test(100〜2000μN) indicate that the laser-treated surface layer modified to GC becomes soft and its friction coefficient increases as compared with that of the untreated DLC.
|
