2007 Fiscal Year Final Research Report Summary
Development of a Plasmonic Band Gap Laser
| Project/Area Number |
17360033
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Applied optics/Quantum optical engineering
|
|---|
| Research Institution | The Institute of Physical and Chemical Research |
|---|
Principal Investigator |
OKAMOTO Takayuki The Institute of Physical and Chemical Research, Nanophotonics Laboratory, Senior Research Scientist (40185476)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
HDHILI Fekhra RIKEN, Nanophotonics Laboratory, Contract Researcher (80392091)
馮 晶 独立行政法人理化学研究所, 河田ナノフォトニクス研究室, 協力研究員 (30392088)
OKAMOTO Takayuki RIKEN, Nanophotonics Laboratory, Senior Research Scientist (40185476)
FENG Jing RIKEN, Nanophotonics Laboratory, Contract Researcher
|
|---|
| Project Period (FY) |
2005 – 2007
|
| Keywords | plamonics / surface nlasmon / plasmonic crystal / plasmonic band gap / laser / organic light emitting devices |
|---|
| Research Abstract |
We investigated the optimal structure of plasmonic crystals for a plasmonic band gap laser. The use of long-range surface plasmons (LRSPs), which are supported in thin metallic films, is required to minimize the absorption loss. We showed that thin metallic films whose surfaces are covered by materials with different dielectric constants could support LRSPs, if we optimize the thickness of one of the materials. The resultant loss coefficient was lower than the gain coefficient of the gain material. We showed that thin films of which both surfaces are corrugated symmetrically to the film center produce the widest plasmonic band gaps. We also showed that in this structure, the plasmon at one of the plasmonic band-gap-edges has no radiation loss. We proposed thin metallic films with one corrugated surface and one flat surface, which are easy to fabricate, as candidates for the Laren These studies were done for one-dimensional plasmonic crystals. We developed software for the analysis of two-dimensional plasmonic crystals.
We applied plasmonic crystals to organic light emitting devices (OT F.Ds). We extracted the emission through the top metallic cathode of the OJ Ens by replacing the usual flat cathode with a plasmonic crystal film The bottom emission was enhanced by a factor of four compared with usual flat OLEDs. We obtained highly directional emission (angular width: 4 degrees) from OLEDs with a plasmonic crystal cathode and a europium complex as the emission material We developed color tunable top-emitting OT ET)s with a metal-dielectric-metal cathode without corrugation.
|
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
[Presentation] Plasmonic bandgap emission devices2006
Author(s)
Takayuki Okamoto, Jing Feng, Janne Simonen, Satoshi Kawata
Organizer
The 9th International Conference on Near-field Nano Optics & Related Techniques(nfo-9)
Place of Presentation
Lausanne, Swiss
Year and Date
20060910-15
Description
「研究成果報告書概要(欧文)」より
-
[Presentation] Second harmonic generatio from plasmonic2006
Author(s)
Kazuma, Tsuboi, Takayuki Okamoto, Kotaro Kajikawa
Organizer
The 9th International Conference on Near-field NanoOptics & Related Techniques(nfo-9)
Place of Presentation
Lausanne, Swiss
Year and Date
20060910-15
Description
「研究成果報告書概要(欧文)」より
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
[Presentation] プラズモニック結晶とは2005
Author(s)
岡本隆之
Organizer
第66回応用物理学会学術講演会シンポジウム
Place of Presentation
徳島
Year and Date
20050907-11
Description
「研究成果報告書概要(和文)」より
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
