2012 Fiscal Year Final Research Report
Development onfixed abrasivetool with continuous pore
| Project/Area Number |
22560104
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Production engineering/Processing studies
|
|---|
| Research Institution | The University of Tokyo |
|---|
Principal Investigator |
KAMIMURA Yasuyuk 東京大学, 生産技術研究所, 技術専門職員 (20396906)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
TSUCHIYA Kensuke 東京大学, 生産技術研究所, 准教授 (80345173)
|
|---|
| Project Period (FY) |
2010 – 2012
|
| Keywords | 複合めっき / 固定砥粒 / スパイラルワイヤ / 目詰まり / ドレスレス / 気孔 |
|---|
| Research Abstract |
In this study, the occurrence of loading was compared between our proposed fixed-abrasive tool and general-purpose tools. It was found that the causes of loading were (1) the formation of a chip pocket due to a high abrasive-grain density, (2) an increase in the contact area between the tool and the workpiece, and (3) the absence of continuous pore around the abrasive grains. Moreover, swarf larger than the grain size were observed for the tool with loading, whereas no such swarf were observed for the tool without loading even when the tool contained fine abrasive grains. In the manufacture of fixed-abrasive tools, therefore, the abrasive grains percentage in the tools should be50% or lower, regardless of their grain size.
|
Research Products
(8 results)
