2013 Fiscal Year Final Research Report
Development of Calibrator for Tail-Oscillating Lightning Impulse Waveform
Project/Area Number |
23560317
|
Research Category |
Grant-in-Aid for Scientific Research (C)
|
Allocation Type | Multi-year Fund |
Section | 一般 |
Research Field |
Power engineering/Power conversion/Electric machinery
|
Research Institution | Utsunomiya University |
Principal Investigator |
SATO Shuji 宇都宮大学, 工学(系)研究科(研究院), 教授 (10215759)
|
Co-Investigator(Kenkyū-buntansha) |
OKAMOTO Yoshifumi 宇都宮大学, 大学院工学研究科, 助教 (40415112)
|
Project Period (FY) |
2011 – 2013
|
Keywords | 波尾振動性雷インパルス電 圧波形 / 低インピーダンス負 / インパルス電圧波形校正器 / IEC 61083-2 TDG |
Research Abstract |
As scheduled IEC 61083-2 (Instruments and software used for measurement in high-voltage and high-current test- Requirement for software for tests with impulse voltages and currents) was issued on March 2013 and appendant TDG (Test Data Generator) was also supplied. As the results of this research, a calibrator, which is capable of generating a tail-oscillating impulse voltage waveform referred as OLI-M3 in TDG, was successfully completed. The generation is possible even when its output is connected to a low impedance (10kOhm) potential divider. By using MOS-FET instead of wetted mercury rely as a switching element of the calibrator, deterioration of the contact can be avoided. Massive parallel connection of MOS-FET makes it possible to reduce the non-linear resistive characteristics between source and drain to a negligibly small level. Also, inherent characteristics of MOS-FET in allowable current from source to drain was solved by that parallel connection.
|
-
-
-
-
-
-
-
-
-
-
-
[Presentation] Investigation on Influence of Current Interruption on V-t Characteristics of Vacuum Interrupters2013
Author(s)
S. Sato, T. Furukawa, M. Ueda, K. Hidaka, H. Ikeda, A. Kumada, S. Nishimura, H. Shimizu, T. Shioiri, M. Homma
Organizer
ARDAC 2013, Poster Presentation
Place of Presentation
Abu-Dhabi, UAE
Year and Date
20130300
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-