1987 Fiscal Year Final Research Report Summary
Research on Tendon Control System for Flexible Space Structures
| Project/Area Number |
60460076
|
|---|
| Research Category |
Grant-in-Aid for General Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Research Field |
Aerospace engineering
|
|---|
| Research Institution | University of Osaka Prefecture |
|---|
Principal Investigator |
MUROTSU Yoshisada College of Eng, Univ. of Osaka Prefecture (Professor), 工学部, 教授 (50081386)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
HASHIMOTO Masafumi do. (Research Associate), 工学部, 助手 (10145815)
MITSUYA Akira do. (Research Associate), 工学部, 助手 (40081260)
TSUJIO Shozou do. (Assistant Professor), 工学部, 講師 (40081252)
OKUBO Hiroshi do. (Research Associate), 工学部, 助手 (40094502)
SHIBATA Hiroshi College of Eng., Univ. of Osaka Prefecture (Professor), 工学部, 教授 (80094506)
|
|---|
| Project Period (FY) |
1985 – 1987
|
| Keywords | Tendon control / Large Space Structure / Structural Control / Vibration Control / Active Control / ロバスト制御 |
|---|
| Research Abstract |
1. Studies on the Design of Tendon Control System
(1) Output Feedback Control (Low-Authority Control; LAC): A useful method is developed for determining the optimum output feedback gains and moment-arm location for the design of tendon control system for large flexible space structures. The proposed method employs a nonlinear programming technique to optimize the design parameters so that the closed-loop poles may be placed in the complex plane as close to the desired pole locations as possible.
(2) Modal Control by State Feedbacks (High-Authority Control; HAC): Investigated are two design approaches which provide the designed controller with stabillity robustness and avoid instability due to mode truncation errors (spillovers). One is (a) LAC/HAC design method and the other is (b) the loop Transfer Recovery (LTR) approach. The effectiveness of the former method is verified by numerical simulations.
2. Laboratory Experiment of Tendon Control System for a Flexible Beam
The prototype tendon
… More
control system has been built for a blexible beam control experiment in the laboratory. It consists of a pair of moment arms mounted on the beam, an electrodynamic force actuator and a rotating link at the beam root, and tensile cables (tendons) connecting the link with the moment arms. The hardware experiment has been done successfully, which shows the fundamental feasibility of the tendon control system for the active vibration control of highly flexible structures.
(1) Modeling and Identification of the Dynamics of the Experimental Tendon Control System: A mathe- matical model of the coupled beam/tendon system dynamics has been constructed with a finite element method(FEM). Included in the modeling are the contributions of gravitational force, axial static load generated by the tension cables, and proportional dampings. The tendon actuator is modeled as an added one-degre-of-freedom vibrating system. The unknown parameters in the FEM model are determined from the measured responses. The result shows satisfying agreement between the theory and the experiment.
(2) Direct Velocity Feedback Control Experiment: Velocity feedback control scheme has been applied to the developed tendon control system. Either of the angular velocity of the moment arms of that of the rotating link was fedback to the electrodynamic actuator. The former system caused a closed-loop instability due to the cynamics of the tendon actuator, whereas the latter showed a stable control and effective vibration damping. These facts show that the dynamics of the tendon actuator system plays an important role in the control system design. Less
|
Research Products
(8 results)
