1988 Fiscal Year Final Research Report Summary
New Type of Polymer Coating System onto Metal Surface from Polymer Emulsion
| Project/Area Number |
61850172
|
|---|
| Research Category |
Grant-in-Aid for Developmental Scientific Research
|
| Allocation Type | Single-year Grants |
|---|
| Research Field |
高分子物性
|
|---|
| Research Institution | Kobe University |
|---|
Principal Investigator |
OKUBO Masayoshi Faculty of Engineering, Kobe University, Associate Professor, 工学部, 助教授 (30031131)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
神門 登 ハニー化成, 常務取締役
NISHINO Takashi Faculty of Engineering, Kobe University, Research Associate, 工学部, 助手 (40180624)
UEDA Yasukiyo Faculty of Engineering, Kobe University, Research Associate, 工学部, 助手 (40116190)
SHINMON Noboru Akashi Laboratory, Honny Chemicals General Manager
|
|---|
| Project Period (FY) |
1986 – 1988
|
| Keywords | Chemical Deposition / Coatings / Paint / Polymer Emulsion / Aluminum / Emulsion Polymerization / Latex / アルミサッシ |
|---|
| Research Abstract |
It is well knowen that electrodeposition is used worldwide as a technique for polymer coatings onto a metallic surface. Recently we have proposed a similar coating process in which the oplymer could be deposited onto an anodized aluminum plate without applied electric current only by immersing it into an anionic polymer emulsion the pH of which was adjusted below about 3. We have termed this coating process as "chemical deposition". According to a series of fundamental investigations on it, as pointed in underlines below, there were some serious problems which is required to improve for applying it industrially. The purpose of this project is to improve them and we have succeeded it as follows:
1. We had usd hydrochloric acid to adjust the pH. Because of it, the properties of coatings had no high quality. We colud apply some organic acids such as formic acid and propionic acid in place of it. 2. The coating thickness decreased with an increase in the number of repeated use of the emulsion bath. We could improve the problem to use some masking agents for aluminum ions which are accumulated therein by dissolving from the aluminum plate every dipping. 3. We had to use emulsifier-free polymer emulsion, because emulsifier molecules, especially free ones gave a bad influence in the chemical deposition. the emulsifier-free emulsion had no good long storage stability. We could improve the problem by applying a polymerizable emulsifier in the preparation of polymer emulsion.
|
Research Products
(23 results)
