Study of the Thermal and Fluid Dynamical Effects on the Heat Removal in the Vicinity of Spacers for Supporting a Fuel Rod in a Nuclear Reactor
Project/Area Number |
01550149
|
Research Category |
Grant-in-Aid for General Scientific Research (C)
|
Allocation Type | Single-year Grants |
Research Field |
Fluid engineering
|
Research Institution | Kyushu University |
Principal Investigator |
FUKANO Tohru Kyushu Univ., Dept. of Mech. Eng., Professor, 工学部, 教授 (60037968)
|
Co-Investigator(Kenkyū-buntansha) |
KADOGUCHI Katsuhiko Kyushu Univ., Dept. of Mech. Eng., Associate for Power Professor, 工学部, 助教授 (60194867)
OUSAKA Akiharu Univ. of Tokushima, Technical, Associate College Professor, 工業短期大学部, 助教授 (70035806)
|
Project Period (FY) |
1989 – 1990
|
Project Status |
Completed (Fiscal Year 1990)
|
Budget Amount *help |
¥1,900,000 (Direct Cost: ¥1,900,000)
Fiscal Year 1990: ¥300,000 (Direct Cost: ¥300,000)
Fiscal Year 1989: ¥1,600,000 (Direct Cost: ¥1,600,000)
|
Keywords | Nuclear reactor / Gas-liquid two-phase flow / Liquid film breakdown / Marangoni convection / Flat-plate-type obstacle / Leading edge down-wash / 界面増速現象 / 二層モデル / 波動領域 / 加熱壁 / 水膜蒸発 / スペ-サ / 熱除去特性 / 高速気流 / 薄膜流 / 液膜破断 / マランゴニ効果 |
Research Abstract |
In order to make clear the fluid dynamical mechanisms causing the liquid film breakdown on the fuel rod in BWR, the following two kinds of fundamental investigation were made. 1. The effect of the thermocapillary convection on the breakdown of a horizontal thin water layer, with its surface locally heated, was examined. We made a visual observation by using the tracer method and proposed an analytical model. In the case that the thickness of the layer is larger than 2 mm, both the observed and calculated results showed that vortices are induced in the layer and the surface profile changes transiently. On the other hand if the layer thickness is much less than 2 mm, the liquid cannot flow into the position just below the locally heated surface, causing the thinning of the layer at that position. This phenomenon, which was shown by calculation only, has the effect of promoting the film breakdown. 2. To simulate a spacer supporting a fuel rod in BWR, a flat-plate-type obstacle was set in an air-water stratified flow in the horizontal and inclined ducts with rectangular cross section and the effects of the flat plate on the film breakdown was experimentally investigated. The results are as follows : The plate itself does not promote the liquid film breakdown but the projection connected on the lower side of the plate has a strong effect on it. In the case of the gas flow velocity of 60 - 70 m/s, film breakdown occurred in front of the projection due to the leading edge down-wash of the stream and due also to the rejection of water by gravitational force in the case of the upward flow in the inclined duct. It also occurred just downstream of the projection in the case of the lower gas velocity. By setting a hole in front of the projection the occurrence of the dry patch formation was delayed.
|
Report
(3 results)
Research Products
(7 results)