Development of Simulator for Plate Bending by Line-Heating
Grant-in-Aid for Scientific Research (A).
|Research Institution||The Uiversity of Tokyo|
NOMOTO Toshiharu University of Tokyo, Faculty of Engineering, Professor, 工学部, 教授 (80011170)
AOYAMA Kazuhiro University of Tokyo, Faculty of Engineering, Asistant, 工学部, 助手 (80222488)
OTSUKA Morizou University of Tokyo, Faculty of Engineering, Asistant, 工学部, 助手 (30010896)
ENOSAWA Makoto University of Tokyo, Faculty of Engineering, Asistant, 工学部, 助手 (40011077)
OTSUBO Hideomi University of Tokyo, Faculty of Engineering, Professor, 工学部, 教授 (20011132)
KOYAMA Takeo University of Tokyo, Faculty of Engineering, Professor, 工学部, 教授 (10010696)
|Project Fiscal Year
1992 – 1994
Completed(Fiscal Year 1994)
|Budget Amount *help
¥15,500,000 (Direct Cost : ¥15,500,000)
Fiscal Year 1994 : ¥3,400,000 (Direct Cost : ¥3,400,000)
Fiscal Year 1993 : ¥2,600,000 (Direct Cost : ¥2,600,000)
Fiscal Year 1992 : ¥9,500,000 (Direct Cost : ¥9,500,000)
|Keywords||Line Heating / Plate Bending / Simulation / Structural Analysis / FEM / CIM / In-plate Shrinkage / Angular Distortion / 線状加熱 / 板曲げ加工 / シミュレーション / 構造解析 / 面内収縮 / 面外変形 / 撓鉄(ぎょうてつ)作業 / シミュレータ / 有限要素解析 / 熱収縮 / 非線形大撓み解析 / 高周波誘導加熱 / 撓鉄 / 曲がり板 / モデル / アイリパラメトリック要素 / 厚板 / 大たわみシェル解析|
The most characteristic work in shipbuilding industry is to bend thick-steel plates. It is often said that plate bending technique is one of the most difficult ones.
In order to solve those technological problem, a lot of investigations were conducted in the past 30 years in Japan.
1) The universal press with multiple piston heads for automate plate bending
2) Development of the artificial intelligence and expert system based on shipbuilding skills
Our aim of this research is developing a simulator for plate bending by Line-Heating. The principle of plate bending due to line heating can be explained as follows. When a plate is heated from one side of plate surface, temperature distribution is produced in the direction of plate thickness. This temperature distribution causes two types of deformation. One is angular distortion and the other is in-plate shrinkage. Those are the results from thermal plastic strains induced during line heating process.
In order to carry a simulation of line heating process by numerical calculation, modeling of line heating process is very important. Therefore, we decide to carry elastic finite element calculation. So the simulator system was based on a simplified non-linear elastic plate bending model instead of thermal elasto-plastic and large deformation analysis.
The finite element calculation subjected to equivalent moment and load. Bending moment M which induces angular distortion and in-plate load F which induces transverse shrinkage are applied.
So user can understand plate bending intuitively and acquire know-how of it. The simulator is useful to a training facility for technicians.
Research Output (3results)