Heating of FRC plasma electron and improvement of confinement by intense pulsed ion beam
Project/Area Number |
06452423
|
Research Category |
Grant-in-Aid for General Scientific Research (B)
|
Allocation Type | Single-year Grants |
Research Field |
プラズマ理工学
|
Research Institution | Osaka University |
Principal Investigator |
OHI Shoichi Osaka University Faculty of Engineering, Plasma Physics Laboratory, 工学部, 助教授 (50029154)
|
Co-Investigator(Kenkyū-buntansha) |
OHKUBO Mamoru Osaka University Faculty of Engineering, Plasma Physics Laboratory, 工学部, 助手 (50243168)
SUGIMOTO Satosi Osaka University Faculty of Engineering, Plasma Physics Laboratory, 工学部, 助手 (70187665)
KAKO Masasi Osaka University Faculty of Engineering, Plasma Physics Laboratory, 工学部, 助手 (80093392)
OKADA Sigefumi Osaka University Faculty of Engineering, Plasma Physics Laboratory, 工学部, 教授 (40135661)
GOTO Seiichi Osaka University Faculty of Engineering, Plasma Physics Laboratory, 工学部, 教授 (90029140)
|
Project Period (FY) |
1994 – 1995
|
Project Status |
Completed (Fiscal Year 1995)
|
Budget Amount *help |
¥1,900,000 (Direct Cost: ¥1,900,000)
Fiscal Year 1995: ¥1,900,000 (Direct Cost: ¥1,900,000)
|
Keywords | FRC plasma / FRC plasma formation device / FRC plasma confinement / FRC plasma transport / plasma heating / pulsed ion beam / magnetically insulated ion beam / FRCプラズマ加熱 |
Research Abstract |
A theoretical and experimental investigation on FRC plasma transport revealed a confinement scaling of plasma particle and trapped magnetic flux which indicated that the transport mechanism of particle and trapped flux was classical and the decay time time of particle (tau_N) was f (alpha)・tau_c/{l+1.2x10^3・epsilon^<-2.7>}, where tau_c was a characteristic time of 1-D (radial) MHD classical the flux-decay (mu・r_s^2/4・eta_<cla.>, mu : permeability and eta_<cla.> : Spitzer's resistivity) and epsilon was a plasma aspect ratio (=l_s/2r_s, : r_s plasma radius and l_s : its length). The decay time of trapped flux (tau_<phi>) was alpha・tau_N and a value of f (alpha) was around 0.3 for alpha=1. Two methods were proposed in order to verify the scaling law. The first was the plasm formation of as high value of epsilon as possible to confirm its dependence on plasma geometry. The second was plasma electron heating to its basic feature of the classical transport by the axial injection of a magnetic
… More
ally insulated, electrode-geometrically focused, and pulsed intense ion beam of several ten NW (-50keV,-kA,and * 10mus), an ion diode of which had been under construction. During the term of this project, constructed was a plasma generation device with a pinch coil of 22cm in diameter and 150cm in length and with extenal field of 8kG at the maximum and of 1.6mus in rising, on the device of which formed might be an FRC plasma of r_s=9cm and l_s=100-120cm (epsilon=ll-14). Its value of tau_N corresponded to 0.37-0.48・f・tau_c (130-170mus for Te=100eV and alpha=1). The device was coming to operate soon. An efficiency of heating plasma by the axial injection of the 50keV proton was estimated numerically for the hydrogen plasma of a dimension shown above using a rather realistic profile of FRC,which was deduced from a 2-D pressure equilibrium calculation combined with the 1-D plasma transport simulation. The efficiency o heat the plasma inside the separatrix was 30% for Te=50eV and about 10% for Te=100eV.This value might be enough to the plasma significantly by the pulsed ion beam. Less
|
Report
(3 results)
Research Products
(4 results)