| Project/Area Number |
06660312
|
|---|
| Research Category |
Grant-in-Aid for General Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Research Field |
農業機械学
|
|---|
| Research Institution | University of Tsukuba |
|---|
Principal Investigator |
TAKIGAWA Tomohiro Institute of Agricultural and Forest Engineering University of Tsukuba, Associate Professor, 農林工学系, 助教授 (00236382)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
NOGUCHI Ryozou Institute of Agricultural and Forest Engineering University of Tsukuba, Research, 農林工学系, 助手 (60261773)
KUROISHI Iwao Institute of Agricultural and Forest Engineering University of Tsukuba, Lecturer, 農林工学系, 講師 (70015668)
KOIKE Masakukio Institute of Agricultural and Forest Engineering University of Tsukuba, Professo, 農林工学系, 教授 (60032306)
|
|---|
| Project Period (FY) |
1994 – 1995
|
| Project Status |
Completed (Fiscal Year 1995)
|
| Budget Amount *help |
¥1,900,000 (Direct Cost: ¥1,900,000)
Fiscal Year 1995: ¥900,000 (Direct Cost: ¥900,000)
Fiscal Year 1994: ¥1,000,000 (Direct Cost: ¥1,000,000)
|
|---|
| Keywords | Front Loader / Agricultural Machinery / Handling / ハンドリング |
|---|
| Research Abstract |
In order to increase adaptability of operations and to realize easier operation, we investigate computer controlled front loaders which have more degrees of mechanical freedom than traditional ones.
Main results obtained by the research are as follows :
1. Mechanical configurations of the front loader was investigated by conducting computer simulations. The results of simulations indicates that range of the motion speed of front loaders is limited due to the lack of linearity of flow control valves. The ratio between maximum speed to the minimum cannot exceed about 10.
2. An experimental front loader with two arms was assembled. Main components are hydraulic pumping unit, hydraulic cylinders and electronic flow control valves. Personal computer was used to control the front loader. When the moving speed of cylinders is slow, the stick slip interferes smooth movement. But we can get smooth movement by applying a short large input to the flow controller.
3. Software to realize basic movement required for operations of the experimental front loader was developed.
4. Small joy stick was used for the inputting device of human operators.
|
