| Project/Area Number |
07455053
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Materials/Mechanics of materials
|
|---|
| Research Institution | Kobe University |
|---|
Principal Investigator |
TOMITA Yoshihiro Kobe University, Faculty of Engineering Professor, 工学部, 教授 (10031147)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
TADA Yukio Kobe University, Faculty of Engineering, Professor, 工学部, 教授 (70135812)
ADACHI Taiji Kobe University, Faculty of Engineerign, Research Associate, 工学部, 助手 (40243323)
NAKAI Yoshikazu Kobe University, Faculty of Engineerign, Associate Professor, 工学部, 助教授 (90155656)
SHIBUTANI Youji Kobe University, Faculty of Engineering, Associate Professor, 工学部, 助教授 (70206150)
|
|---|
| Project Period (FY) |
1995 – 1996
|
| Project Status |
Completed (Fiscal Year 1996)
|
| Budget Amount *help |
¥7,600,000 (Direct Cost: ¥7,600,000)
Fiscal Year 1996: ¥2,000,000 (Direct Cost: ¥2,000,000)
Fiscal Year 1995: ¥5,600,000 (Direct Cost: ¥5,600,000)
|
|---|
| Keywords | Mesoscale / Strain-induced martensitic phase transformation / TRIP / Functional material / FEM / Micro hardness / メゾ・スケールモデル / 変形誘起変態 / ポリマー / 高分子鎖 / 内部構造変化 / 構成モデル / シミュレーション |
|---|
| Research Abstract |
A TRIP (transformation-induced plasticity) steel possesses such desirable mechanical properties as high strength, ductility and toughness due to the effect of strain-induced martensitic transformation. However such properties are achieved only under certain restricted conditions since the transformation strongly depends on temperature, applied strain and strain rate as well as their history. The transformation mechanism contrbiuting to the local deformation may be difficult to comprehend full based on any experimental methods. Numerical simulations with more appropriate constitutive equation are, therefore, indispensable.
In this study, uniaxial tension tests at several environmental temperatures are carried out to fit the material parameters defined in the constitutive equation. Elastic-viscoplastic finite-element simulations nsing the constitutive equation are performed and the volume fraction of martensite phase measured by using a micro hardness testing is utilized to elucidate the validity of the proposed constitutive equation in the analysis of nonuniform deformation behavior. Then the deformation behavior and the toughuess improvememt mechanism associated with strain-induced martensitic trans-formations around notch tip has been clarified.
Around the room temperature, the reduction of phase transformation rate due to decreasing of driving force with temperature rising prevents the excessive transformation around the notch tip which suppress the stress concentration as compared with that at the low teperature range. As a result, occurance of cracking is substantially delayd, which yields the improvement of the toughness.
|
