| Project/Area Number |
09650137
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
機械工作・生産工学
|
|---|
| Research Institution | Nagoya Institute of Technology |
|---|
Principal Investigator |
MATSUBARA Tomio Nagoya Institute of Technology, Faculty of Engineering, Professor, 工学部, 教授 (20026032)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
MABUCHI Eiji Nagoya Institute of Technology, Faculty of Engineeering, Assistant, 工学部, 助手 (80024264)
NAKAMURA Takashi Nagoya Institute of Technology, Faculty of Engineeering, Associate Professor, 工学部, 助教授 (40135314)
|
|---|
| Project Period (FY) |
1997 – 1998
|
| Project Status |
Completed (Fiscal Year 1998)
|
| Budget Amount *help |
¥3,300,000 (Direct Cost: ¥3,300,000)
Fiscal Year 1998: ¥1,100,000 (Direct Cost: ¥1,100,000)
Fiscal Year 1997: ¥2,200,000 (Direct Cost: ¥2,200,000)
|
|---|
| Keywords | ULTRA HIGH SPEED MACHINING / DRILLING / MICRO MACHINING / PRINT CIRCUIT BOARD / OIL MIST / HSS TOOL / SINTERDCARBIDETOOL / NONCONTACTMEASURING / ステップフィード / 微細ドリル加工 / 超高速回転 / 全静圧被削材ホルダー / 微小スラスト検出 / 微小トルク検出 |
|---|
| Research Abstract |
In this study. an ultra high speed micro drilling system was made by using a precision X-Y servo driving table.The glass epoxy print circuit board(PCB) was drilled by the above system under various drilling conditions. The drilling performances of HSS drills with 40-100 mum in diameter were tested under dry and wet conditions. As the results, it was shown that the drill feed rate 2 IOTAm /rev with higher drill speed under wet condition was suitable for micro drilling of PCB.Stepping feed also gave good results. The effect of oil supply on micro drilling operations was very significant. Especially, the oil supply was very effective to reduce the torque which is the main cause of micro drill damage and lower tool life. The sintered carbide drill resulted in longer tool life and higher quality of drilled hole surfaces and In reducing the bar due to lower tool wear. Oil mist application was also very effective to improve the micro drilling performance. As the result of this study, it was made clear that the ultra high speed micro drilling with sintered carbide tool was effective to drill out many micro hole S on PCB under oil mist conditions.
|
