Project/Area Number |
10555205
|
Research Category |
Grant-in-Aid for Scientific Research (B)
|
Allocation Type | Single-year Grants |
Section | 展開研究 |
Research Field |
Architectural environment/equipment
|
Research Institution | TOHOKU UNIVERSITY (1999) Niigata Institute of Technology (1998) |
Principal Investigator |
MOCHIDA Akashi Graduate School of Engineering, Tohoku University, Associate Professor, 大学院・工学研究科, 助教授 (00183658)
|
Co-Investigator(Kenkyū-buntansha) |
TOMINAGA Yoshihide Faculty of Engineering, Niigata Institute of Technology, Associate Professor, 工学部, 助教授 (00278079)
SATO Hiroshi Graduate School of Engineering, Tohoku University, Lecturer, 大学院・工学研究科, 講師 (10260423)
YOSHINO Hiroshi Graduate School of Engineering, Tohoku University, Professor, 大学院・工学研究科, 教授 (30092373)
TAKAHASHI Masao Industrial Science Department of Nakajo Works, Mizusawa Industrial Chemicals LTD., Vice Director, 中条工場生産技術部, 次長(研究職)
AOKI Yasunobu Planning & Construction Department, Coal Mining Area Development, Japan Regional Development Corporation, Senior Officer, 産炭地域振興事業部, 調査役(研究職)
清水 敬二 新潟工科大学, 工学部, 教授 (50143813)
|
Project Period (FY) |
1998 – 1999
|
Project Status |
Completed (Fiscal Year 1999)
|
Budget Amount *help |
¥10,900,000 (Direct Cost: ¥10,900,000)
Fiscal Year 1999: ¥4,900,000 (Direct Cost: ¥4,900,000)
Fiscal Year 1998: ¥6,000,000 (Direct Cost: ¥6,000,000)
|
Keywords | Blown Sand / Roughness on Ground / Industrial Waste / Field Measurement / Wind Tunnel Test / Computational Fluid Dynamics / 環境障害 / 防止対策 |
Research Abstract |
Blown sand is a serious problem for the inhabitant in the coastal area. The damage is especially serious in the district facing the Japan Sea where seasonal wind is very strong in winter. In order to reduce the strong wind which causes the blown sand, the wind break fence and the net are widely used. But such measures have a problem that the perspective and the landscape at the coastline are much prevented. The new type of countermeasure for mitigating the environmental problems due to the blown sand is developed. Here, the blown sand is prevented by spraying the clod generated from the chemical industry as the waste. The performance of developed method is tested based on results of field measurements, wind tunnel tests and numerical predictions using CFD technique.
|