Evaluation of Tribological Performance of High Functional Surface Midified Machine Element under High Temperature in High Vacuum
| Project/Area Number |
10650147
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
設計工学・機械要素・トライボロジー
|
|---|
| Research Institution | OKAYAMA UNIVERSITY |
|---|
Principal Investigator |
FUJII Masahiro FACULTY OF ENGINEERING, OKAYAMA UNIVERSITY, ASSOCIATE PROFESSOR, 工学部, 助教授 (80209014)
|
|---|
| Project Period (FY) |
1998 – 2000
|
| Project Status |
Completed (Fiscal Year 2000)
|
| Budget Amount *help |
¥3,300,000 (Direct Cost: ¥3,300,000)
Fiscal Year 2000: ¥800,000 (Direct Cost: ¥800,000)
Fiscal Year 1999: ¥600,000 (Direct Cost: ¥600,000)
Fiscal Year 1998: ¥1,900,000 (Direct Cost: ¥1,900,000)
|
|---|
| Keywords | Surface Modification / Tribology / High Vacuum / High Temperatue / Machine Element / Friction / Wear |
|---|
| Research Abstract |
In order to evaluate the tribological characteristic and peformance of high functional modified surface, the comprehensive experiment and analysis were performed under high temperature in high vacuum.
Kinds of high functional sliding materials were wear-tested under high temperature in high vacuum and the information of their ability were obtained.
In order to clarify the influence of surface modification on rolling contact fatigue strength the surface modified rollers were fatigue-tested and their contact pressure and subsurface stresses were analysed with the boundary element method. The reason why the improvement of rolling contact fatigue strength by surface modifications would be due to the reduction of contact pressure and subsurface stresses.
Various electroless Ni platings were wear-tested with a two-cylinder test machine and the influence of dispersed particles in the plated layer on friction and wear behaviors was investigated with the finite element method analysis. When the elastic modulus of the dispersed particles is smaller than that of the matrix, the maximum shear stress and Mises stress around the dispersed particles become large, resulting in wear increasing. It was indicated how to decide the optimum particle size.
Fractal dimensions of various worn surfaces were analysed with data measured with a profile meter and a laser-scanning microscope, and applied to the evaluation of worn surface. It was obvious that the more beneficial information could be obtained using fractal dimensions analysed with both instruments.
|
Report
(4 results)
Research Products
(22 results)
