| Project/Area Number |
11450084
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B).
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Thermal engineering
|
|---|
| Research Institution | Tokyo Institute of Technology |
|---|
Principal Investigator |
MATSUI Yukio Tokyo Institute of Technology, Dept. of Mechanical and Aerospace Engrg., Professor, 大学院・理工学研究科, 教授 (50301172)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
KIMURA Shuji Nissan Motors, Co., Nissan Research Center, Researcher, 総合研究所, 研究員
KOSAKA Hidenori Tokyo Institute of Technology, Dept. of Mechanical and Aerospace Engrg., Associate Professor, 大学院・理工学研究科, 助教授 (50225413)
|
|---|
| Project Period (FY) |
1999 – 2000
|
| Project Status |
Completed (Fiscal Year 2000)
|
| Budget Amount *help |
¥6,800,000 (Direct Cost: ¥6,800,000)
Fiscal Year 2000: ¥1,700,000 (Direct Cost: ¥1,700,000)
Fiscal Year 1999: ¥5,100,000 (Direct Cost: ¥5,100,000)
|
|---|
| Keywords | Fuel Injection System / Common Rail / Intermittent Injection / Injection Rate Control / Ignition Delay / Unsteady Diffusion Combustion / Diesel Engine / Rapid Compression Machine |
|---|
| Research Abstract |
A new fuel injection system was developed at first based on a common rail injection system in this research. Prior to this development, numerical simulation code was made in order to estimate the effects of main elementary parts within this injector and the estimation of the additional pressure booster unit. As a result, the control space volume which is formed at the top of the needle rod and the inlet/outlet orifice diameter which are located in the control volume play important parts, whereas the common rail volume or the length of high pressure tube between the common rail and the injector have no great influence on injection pressure and injection shape.
By the construction of pressure booster, maximum fuel injection pressure has reached 175 MPa. And as to injection rate control, pilot injection, split injection and multiple divided injection were realized by means of the system control program. This system was attached to a rapid compression machine, and single shot combustion tests were performed. This experiment clarified that the ignition delay period is shortened along with the increase of injection pressure in the examined pressure range, and also earlier injection fuel in multiple divided injection made a higher combustion pressure rise rate.
After this experiment, this combustion test apparatus was applied to estimate the heat loss phenomena-in diesel combustion. The heat loss to the combustion chamber wall was apparently affected by orifice diameter and hole number of the injector.
|
