| Project/Area Number |
13450140
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
電子デバイス・機器工学
|
|---|
| Research Institution | Shizuoka University |
|---|
Principal Investigator |
KAWAHITO Shoji Shizuoka University, Research Institute of Electronics, Professor, 電子工学研究所, 教授 (40204763)
|
|---|
| Project Period (FY) |
2001 – 2003
|
| Project Status |
Completed (Fiscal Year 2003)
|
| Budget Amount *help |
¥13,400,000 (Direct Cost: ¥13,400,000)
Fiscal Year 2003: ¥3,300,000 (Direct Cost: ¥3,300,000)
Fiscal Year 2002: ¥4,700,000 (Direct Cost: ¥4,700,000)
Fiscal Year 2001: ¥5,400,000 (Direct Cost: ¥5,400,000)
|
|---|
| Keywords | oversampling / highly sensitive imaging / CMOS image sensor / noise analysis / noise cancel / イメージセンサ / 高感度 / ノイズ低減処理 / 適応ゲイン増幅 / 最小2乗推定 |
|---|
| Research Abstract |
In this, study, new noise reduction techniques based on oversampled signal processing for high-sensitivity image sensors have been investigated. The proposed technique does not require any photo charge multiplication, which is a major technique for highly sensitive imaging. One of the methods uses a multiple sampling of the image array output in non-destructive readout modes. This technique predicts the signal component based on the correlation in the intermediate signal levels in the non-destructive mode of pixel outputs and greatly reduces the output random noise. Another method uses a gain-adaptive amplifier array integrated at the column of the image sensors. An experimental image sensor chip based on 0.25um technology has been developed and the lowest noise level of 260uV in CMOS image sensors is achieved. In order to investigate the low-noise sensor interface, establishment of a noise analysis method for CMOS image sensor interface circuits is indispensable. We have established a noise analysis method for high-gain switched capacitor amplifiers suitable for integrating them at the column of the image sensors. The noise analysis model includes both the thermal and 1/f noises. The analysis shows that a double stage noise-canceling amplifier has extremely low noise level if a noise component sampled at the inside node of the amplifier is cancelled.
|
