Optimized Conditions and High Performing Method of Enhancement of Absorption by Using a Downward Facine Plate
| Project/Area Number |
13650216
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Thermal engineering
|
|---|
| Research Institution | Shinshu University |
|---|
Principal Investigator |
HIMENO Nobuhiro Shinshu University, Faculty of Textile Science and Technology, Associate Professor, 繊維学部, 助教授 (20114887)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
HINATA Shigeru Shinshu University, Faculty of Textile Science and Technology, Professor, 繊維学部, 教授 (80007020)
|
|---|
| Project Period (FY) |
2001 – 2002
|
| Project Status |
Completed (Fiscal Year 2002)
|
| Budget Amount *help |
¥3,500,000 (Direct Cost: ¥3,500,000)
Fiscal Year 2002: ¥1,500,000 (Direct Cost: ¥1,500,000)
Fiscal Year 2001: ¥2,000,000 (Direct Cost: ¥2,000,000)
|
|---|
| Keywords | Enhancement of Absorption / Downward Facing Plate / Steam Absorption / LiBr Aqueous Solution / Absorption Heat Pump |
|---|
| Research Abstract |
The effects of absorbing plate length, concentration of LiBr aqueous solution, and configuration of an absorbing plate have been experimentally investigated on the enhancement of steam absorption into a LiBr aqueous solution by using a downward facing plate, which method the head investigator developed previously, to clarify the optimum conditions and high performing method of the enhancement of absorption. The experiment has been conducted using a finned absorbing plate with fins 1 mm high and 1 mm wide. The groove width varies as 1 mm, 2 mm, 3 mm, 5 mm, 7 mm and 10 mm. The plate width is 50 mm, and the length varies as 50 mm, 180 mm and 250 mm.
1. The Effects of Absorbing Plate Length
The enhancement of absorption by using a downward facing plate grows greater as the absorption plate becomes long. This is because the absorbed water film becomes thick to deteriorate absorption with increasing absorbing plate length, when the enhancement mechanism of absorption does not work.
2. The Effects of Concentration of LiBr Aqueous Solution
The degree of enhancement of absorption by using a downward facing plate does not differ greatly between 30wt% and 60wt% LiBr solutions. When the concentration of LiBr solution increases, growing density difference between the solution and water counterworks with increasing viscosity for the generation of free convection in the liquid film.
3. The Effects of Configuration of an Absorbing Plate
The finned plate having 5 mm groove width shows the greatest enhancement of absorption in the present experiment. Narrow width of the groove makes viscosity effects at the side surface of the fin serious in the whole liquid film, while wide width of that causes non-uniform thickness of the liquid film to deteriorate the generation of free convection at the center of the groove.
|
Report
(3 results)
Research Products
(4 results)
