| Project/Area Number |
14205020
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (A)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Materials/Mechanics of materials
|
|---|
| Research Institution | Wakayama University |
|---|
Principal Investigator |
MORIMOTO Yoshiharu Wakayama University, Faculty of Systems Engineering, Professor, システム工学部, 教授 (20029573)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
NOMURA Takanori Wakayama University, Faculty of Systems Engineering, Associate Professor, システム工学部, 助教授 (80222206)
FUJIGAKI Motoharu Wakayama University, Faculty of Systems Engineering, Associate Professor, システム工学部, 助教授 (40273875)
YONEYAMA Satoru Osaka Prefecture University, School of Engineering, Lecturer, 工学部, 講師 (90306499)
WADA Takao Kawaju Techno Service Corporation, Researcher, 社長付き主幹, 研究職
|
|---|
| Project Period (FY) |
2002 – 2004
|
| Project Status |
Completed (Fiscal Year 2004)
|
| Budget Amount *help |
¥52,650,000 (Direct Cost: ¥40,500,000、Indirect Cost: ¥12,150,000)
Fiscal Year 2004: ¥26,780,000 (Direct Cost: ¥20,600,000、Indirect Cost: ¥6,180,000)
Fiscal Year 2003: ¥17,680,000 (Direct Cost: ¥13,600,000、Indirect Cost: ¥4,080,000)
Fiscal Year 2002: ¥8,190,000 (Direct Cost: ¥6,300,000、Indirect Cost: ¥1,890,000)
|
|---|
| Keywords | Shape and defect inspection / Large structure / Health monitoring / Linear sensor / Phase analysis / Projecting grating / Shape measurement / Reference plane / モアレ法 / 欠陥検査 / 画像処理 / 光学的測定法 |
|---|
| Research Abstract |
We had developed a high-speed and high-accuracy shape and deformation measurement method using Integrated Phase-shifting Method. In this study, we made further development to this method to propose a defect inspection method for the large structure and the continuously moving object. Our achievements are as shown below.
●We made it possible to use the linear sensor to obtain moire fringes without special image processing, which show the contour lines of an object based on the same principle of the scanning moire method.
●We measured an concrete wall with the proposed method and confirmed its efficiency.
●We made a study of the grating projection method to measure the large structure. We proposed a method of in-plane projecting including the capture line of the linear sensor. Using this method, we developed the phase-shifting optical system. We also studied for a method to project the grating efficiently and developed the method of grating projection that projects uniform gratings on the plane.
●We developed the grating projection system with parallel light, the measurement experimental setup and the shape measurement software. We integrated those developments and conducted shape measurement experiments.
●To measure more accurately, we proposed a method of every pixel calibration with multiple reference planes. The result of our shape measurement experiment proved that shape measurement of the continuous object with the resolution of 1 mm or less is realized with this system.
●We confirmed that measurement accuracy can be improved by using multiple planes even though the intensity distribution of the grating pattern is not accurate enough.
●We verified that the proposed method realized the shape measurement with the resolution of 1 mm or less computationally by using the light source with high brightness even if it is conducted by the running train at 300 km/hr.
|
