IMPROVEMENT OF HYDROGENATION PROPERTIES FOR TI-BASED QUASICRUSTAL POWDERS PRODUCED BY MECHANICAL ALLOYING
| Project/Area Number |
15560577
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Physical properties of metals
|
|---|
| Research Institution | SHIBAURA INSTITUTE OF TECHNOLOGY |
|---|
Principal Investigator |
TAKASAKI Akito SHIBAURA INST.OF TECH., DEPT.OF MECHANICAL ENG.II, PROFESSOR, 工学部, 教授 (70286699)
|
|---|
| Project Period (FY) |
2003 – 2005
|
| Project Status |
Completed (Fiscal Year 2005)
|
| Budget Amount *help |
¥3,700,000 (Direct Cost: ¥3,700,000)
Fiscal Year 2005: ¥700,000 (Direct Cost: ¥700,000)
Fiscal Year 2004: ¥700,000 (Direct Cost: ¥700,000)
Fiscal Year 2003: ¥2,300,000 (Direct Cost: ¥2,300,000)
|
|---|
| Keywords | quasicrystal / hydrogenation / hydrogen desorption / mechanical alloying / Ti-Zr / Hf-Ni / hydrogen cycling / amorphous / Ti-Zr-Ni / 水素吸蔵合金 / 粉末治金 / アモルファ / 粉末冶金 |
|---|
| Research Abstract |
Besides the conventional solidification processes like rapid quenching, a combination of mechanical alloying (MA) and subsequent annealing in vacuum was shown to also produce the Ti-Zr-Ni icosahedral phase (i-phase) for a range of chemical composition. Depending upon the chemical compositions, minor phases such as the solid solution phase (α-Ti/Zr) and the Ti_2Ni-type phase (fcc structure) also formed after subsequent annealing The Ti-Zr-Ni i-phase powders could load hydrogen to a concentration greater than 60 at.%. The maximum concentration reached was 67 at% (H/M 【approximately equal】 2.02) which was obtained for the Ti_<45>Zr_<38>Ni_<17> i-phase powder during a high-pressure isotherm measurement. The substitution of Zr atoms for Ti ones in the Ti-Zr-Ni i-phase powders decreased the activation energy for hydrogen desorption and the hydrogen desorption temperatures. Besides the plateau-like pressure observed during the low-pressure isotherm measurement for the i-phase powder an additi
… More
onal plateau was also observed at about 0.5 MPa (desorption process) during a high-pressure isotherm measurement. The i-phase in the Ti-Zr-Ni powder remained stable even after hydrogenation, but the amorphous powders transformed into a fcc (Ti, Zr)H_2 hydride phase, whose activation energy for hydrogen desorption was generally higher than that measured for the i-phase.
The i-phase could also be produced from Ti_<40>Hf_<40>Ni_<20> elemental powders by MA and subsequent annealing, coexisting with a Ti_2Ni-type crystal phase. The amount of the Ti_2Ni-type phase was much larger than obtained in the Ti-Zr-Ni powders. The hydrogen concentration in the Ti_<40>Hf_<40>Ni_<20> i-phase powder was about 55 at.% after loading from the gas phase at 573 K and an initial hydrogen pressure of 3.8 MPa. This was slightly lower than observed for the Ti-Zr-Ni i-phase powders. The activation energy for hydrogen desorption was also lower than for the Ti-Zr-Ni i-phases, suggesting that the substitution of Hf for Zr decreased the chemical interaction between hydrogen in the tetrahedral sites and the surrounding metal atoms. Less
|
Report
(4 results)
Research Products
(25 results)
