Study on Outer Rotor Type Multipolar SR Motor and its Application to Electric Vehicle
| Project/Area Number |
16360131
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
電力工学・電気機器工学
|
|---|
| Research Institution | Tohoku University |
|---|
Principal Investigator |
ICHINOKURA Osamu Tohoku University, Graduate School of Engineering, Professor, 大学院・工学研究科, 教授 (20134017)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
HI-JIAO Guo Tohoku Gakuin University, School of Engineering, Professor, 工学部, 教授 (00224353)
NAKAMURA Kenji Tohoku University, Graduate School of Engineering, Research Assistant, 大学院・工学研究科, 助手 (70323061)
|
|---|
| Project Period (FY) |
2004 – 2005
|
| Project Status |
Completed (Fiscal Year 2005)
|
| Budget Amount *help |
¥15,100,000 (Direct Cost: ¥15,100,000)
Fiscal Year 2005: ¥5,300,000 (Direct Cost: ¥5,300,000)
Fiscal Year 2004: ¥9,800,000 (Direct Cost: ¥9,800,000)
|
|---|
| Keywords | Electric vehicle / Multi-polar SR motor / Outer rotor / In wheel motor / Direct drive / アウターローター型多極SRモータ / リチウムイオン電池 |
|---|
| Research Abstract |
Switched reluctance motor (SR motor) exhibits desirable features including high reliability, good efficiency and low cost because the SR motor has simple and solid structure without permanent magnets and rotor windings. Unfortunately, the SR motor has not been put into practical applications widely because of its large torque ripple and acoustic noise. However, recent motor technology, which includes an optimum design based on FEM and instantaneous current control using DSP or FPGA, overcomes gradually the defects of the SR motor. Some products such as fuel pump, washing machine and vacuum cleaner have been already presented in the practical applications of SR motor.
In this research, we proposed an outer rotor type multi-polar SR motor as a new attempt, and developed a multi-polar SR motor to an small electric vehicle for two years. The obtained results are as follows :
The results obtained in the year 2004
1. Establishment of dynamic analysis method for SR motor.
2. Design of the outer rotor type multi-polar SR motor for electric vehicle.
3. Manufacturing of the outer rotor type multi-polar SR motor for electric vehicle.
4. Manufacturing of the driving circuit and controller for the outer rotor type multi-polar SR motor.
The results obtained in the year 2005
1. Manufacturing the electric vehicle with the developed multi-polar SR motor, the driving circuit and controller.
2. Improvement of the driving circuit and controller for the purpose of reliable operation.
3. Driving experiments.
4. Proposal of new control methods of the SR motor for improvement of the performance of the electric vehicle.
5. Establishment of the optimum design method of the SR motor.
To conclude, we developed a new outer rotor type multi-polar SR motor and realized a direct driving electric vehicle using the developed SR motor in this research. The electric vehicle has good performance. Then the original target of this research has been accomplished.
|
Report
(3 results)
Research Products
(21 results)
