The Evaluation Method of Electromagnetic Disturbance and Interference on Ubiquitous Equipment
Project/Area Number |
16560253
|
Research Category |
Grant-in-Aid for Scientific Research (C)
|
Allocation Type | Single-year Grants |
Section | 一般 |
Research Field |
電力工学・電気機器工学
|
Research Institution | Takushoku University |
Principal Investigator |
SCHIBUYA Noboru Takushoku University, Faculty of Engineering, Professor, 工学部, 教授 (50114822)
|
Co-Investigator(Kenkyū-buntansha) |
TAKAHASHI Takehiro Takushoku University, Faculty of Engineering, Professor, 工学部, 教授 (10206815)
SAKUSABE Takashi Takushoku University, Faculty of Engineering, Research Assistant, 工学部, 助手 (80092485)
|
Project Period (FY) |
2004 – 2006
|
Project Status |
Completed (Fiscal Year 2006)
|
Budget Amount *help |
¥3,600,000 (Direct Cost: ¥3,600,000)
Fiscal Year 2006: ¥600,000 (Direct Cost: ¥600,000)
Fiscal Year 2005: ¥700,000 (Direct Cost: ¥700,000)
Fiscal Year 2004: ¥2,300,000 (Direct Cost: ¥2,300,000)
|
Keywords | ubiquitous equipment / electromagnetic disturbance / noise immunity / near-field measurement / intra-equipment interference / performance degradation / through-put / 電磁干渉(EMC) / ノイズイミュニティ / 基板上の誤動作マップ / パケットエラーレート / 通信品質(スループット) |
Research Abstract |
Recently the electromagnetic interference of intra/inter-equipment has been studied, especially on the small digital device such as ubiquitous equipment. The interference of intra-equipment means that an emission form the equipment interferes to another part of circuit on the equipment itself and this interference causes performance degradation of the equipment. To evaluate the performance degradation of the electronic equipment exposed to the noise, the communication performance, "through-put", was measured in avoiding measurement difficulties of BER(bit error rate). In this study, the performance degradation was measured using through-put under near field electromagnetic disturbance, and the results are compared with the emission from equipment, and good agreement was obtained. To develop the evaluation method of the performance degradation, some communication indexes were measured under EM(electromagnetic) disturbance. From the measured results, the relationship between near field measurement and performance degradation could be obtained in some extent. These facts enable us that the weak area under the EM disturbance application on PCB can be foreseen by measuring the near field emission from the equipment and vise versa. To reduce the risk of the intra-equipment interference, the layout of the parts on the circuit board and also the layout of the circuit boards in the equipment should be well managed in this aspect. It is understood that the circuit has similar characteristics of emission and immunity as mentioned above. Circuits having similar function had better to be located apart each other to avoid electromagnetic coupling. In the further work, the mechanism about the interference of intra-equipment should be cleared and the reduction technique for interference should be investigated.
|
Report
(4 results)
Research Products
(34 results)