• 研究課題をさがす
  • 研究者をさがす
  • KAKENの使い方
  1. 課題ページに戻る

2018 年度 実績報告書

グラフェンの歪みナノ構造のプラズモニクス開拓およびそのセンシングへの応用

研究課題

研究課題/領域番号 16F16332
研究機関東京大学

研究代表者

志村 努  東京大学, 生産技術研究所, 教授 (90196543)

研究分担者 VANTASIN SANPON  東京大学, 生産技術研究所, 外国人特別研究員
研究期間 (年度) 2016-11-07 – 2019-03-31
キーワードnanorige
研究実績の概要

The analytic model for double nanoridge is simple. We model that the SPP wave launched from double nanoridge is just interference result of SPP wave launched by each single ridge, which is already discussed. This phase delay occurs because plasmon wave travel along graphene-air interface. When the plasmon wave propagate over ridge, it must follow the ridge curve, resulting in an extra travelling length compared to that of flat graphene. This delay can be calculated analytic from the difference between right curve length and the straight line under the ridge. We also did the simulation (not shown here) to confirm this phase delay, and the numerical result match the analytic result.
For the right side, the SPP wave launched from 100-nm experienced phase delay from 150-nm ridge before interferes with another SPP wave launched from 150-nm ridge. For the left side, the SPP wave launched from 150-nm ridge also got phase delay from 100-nm ridge. However, the two phase delays are not equal. Therefore, the interference on each side is different, resulting in asymmetric directional plasmon launching.
The ratio of right/left launched amplitude from the analytic model was shown. From this graph, one can choose the condition which provide strong directionality of the plasmon launching. We then use the condition (275 nm ridge separation) to perform simulation. Directional plasmon launching is achieved. Wavelength-sorted launching (same structure, SPP wave goes to left or right side depending on wavelength), is also achieved.

現在までの達成度 (段落)

平成30年度が最終年度であるため、記入しない。

今後の研究の推進方策

平成30年度が最終年度であるため、記入しない。

URL: 

公開日: 2019-12-27  

サービス概要 検索マニュアル よくある質問 お知らせ 利用規程 科研費による研究の帰属

Powered by NII kakenhi