1993 Fiscal Year Final Research Report Summary
Study on surface coating of ultra-fine particles for EEM machining.
| Project/Area Number |
04555035
|
|---|
| Research Category |
Grant-in-Aid for Developmental Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Research Field |
機械工作
|
|---|
| Research Institution | Osaka University |
|---|
Principal Investigator |
MORI Yuzo Osaka Univ.Faculty of Eng.Prof., 工学部, 教授 (00029125)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
YAMAMURA Kazuya Osaka Univ.Faculty of Eng.Research Asst., 工学部, 助手 (60240074)
ENDO Katsuyoshi Osaka Univ.Faculty of Eng.Assoc.Prof., 工学部, 助教授 (90152008)
YAMAUCHI Kazuto Osaka Univ.Faculty of Eng.Assoc.Prof., 工学部, 助教授 (10174575)
KATAOKA Toshihiko Osaka Univ.Faculty of Eng.Prof., 工学部, 教授 (50029328)
|
|---|
| Project Period (FY) |
1992 – 1993
|
| Keywords | EEM / plasma CVD / ultra-fine particle / surface preparation / coating |
|---|
| Research Abstract |
This study aims at making ultra-fine particles for EEM(Elastic Emission Machining). EEM is one of the most precision machining method, utilizing chemical reaction in solid phase between the pariticle surface and the work surface. So that chemical properties and reactivities of each surface atoms is very important. And it is neccesary to select the optimum combination of the particle and the work to achieve efficient machining properties.
Last year, the appratus for making the ultra-fine particles utilizing plasma CVD was designed and constructed. It was found that stable plasma state could be maintained with the condition of continuous feeding the powder particle, and classification of particles with the range from 0.03mum to 1.0mum was possible.
This year, polystirene ultra-fine particle coated with alumina(Al_2O_3) was prepared, and applied to EEM machining of Si wafer. The results are shown as follows.
These results shows ability of the coating system, and significance of coating method.
|
