2006 Fiscal Year Final Research Report Summary
Development and evaluation of fabrication method of functional surfaces for MEMS
| Project/Area Number |
16360066
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Production engineering/Processing studies
|
|---|
| Research Institution | Nagoya University |
|---|
Principal Investigator |
UMEHARA Noritsugu Nagoya University, Graduation School of Engineering, Professor, 大学院工学研究科, 教授 (70203586)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
KOUSAKA Hiroyuki Nagoya University, Graduation School of Engineering, Assistant Professor, 大学院工学研究科, 講師 (90362318)
|
|---|
| Project Period (FY) |
2004 – 2006
|
| Keywords | Functional surface / Friction / Patterning / Plasma / Ion beam / CNx |
|---|
| Research Abstract |
In order to provide the new function to the contact and sliding surfaces for MEMS, it was investigated of the new fabrication method with ultra low friction, low wear rate and low bouncing height slider. The following principle results were obtained.
(1) In order to provide the ultra low friction and low wear properties to the sliding surface, a new high speed coating method of Diamond-like Carbons was developed by using surface wave excited plasma. A metal pipe was coated with DLC by using a sapphire antenna. The its hardness was 21 GPa. The its deviation of the thickness was within 15% along the pipe. The temperature of the pipe was considered as the important parameter to control the structure and mechanical properties of the DLC.
(2) In order to control the bouncing height of a tiny slider during sliding, a new fabrication method of micro asperities on the sliding surface was proposed. Ion-beam irradiation were used to make micro asperities because the heights of those asperities should be less than 100 nm. The Polycarbonate showed uniform asperities in several nm height. The height was controlled by the irradiation ion and plasma species and irradiation period. The effect of the micro patterns on the friction properties was investigated. A few urn height micro pattern showed that, the friction was independent of the sliding velocity.
(3) In order to evaluate local surface energy on the sliding surface, the contact angle of micro condensed liquid drops were measured. By using this method, it was confirmed that the local surface energy as one metal phase in the multi-phase metal was different from the individual surface energy of each metal phase. Also it was confirmed that the cutting condition for the single crystalline Silicon changed not only surface roughness but also surface energy.
|
