2005 Fiscal Year Final Research Report Summary
Development of the thermal design approach for electronic equipment incorporated with electric design and CFD software.
| Project/Area Number |
16560190
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Thermal engineering
|
|---|
| Research Institution | Toyama Prefectural University |
|---|
Principal Investigator |
ISHIZUKA Masaru Toyama Prefectural University, Engineering, Professor, 工学部, 教授 (60326072)
|
|---|
| Project Period (FY) |
2004 – 2005
|
| Keywords | computational fluid dynamics (CFD) / thermal design / switch mode power supply / incorporation with electric design and thermaldesign / modeling of components / estimation of amount of dissipated heat |
|---|
| Research Abstract |
In the design process of electronic equipments early estimates of component temperatures are of great importance. Many tools exist to assist thermal design engineers during this process, including flow network modeling (FNM), computational fluid dynamics (CFD), and well-established heat transfer correlations, and the thermal flow simulation technique is applied to thermal design in the development phase of electronic equipment.
In many electronic equipment, several coil components, such as a transformer and a high-frequency inductor are used and it is a one of the most important component for thermal design. Therefore, in order to improve the accuracy of thermal flow simulation, the coil component needs to be accurately analyzed together with the other components within a single numerical model. However, regarding the system-level thermal simulation, there are few reports in which the detail of modeling method for coil component is documented. The purpose of this study is to develop the
… More
compact thermal modeling method of coil component applicable to the system-level thermal flow simulation. This study especially focused on high-frequency inductor as the coil component.
In the proposed modeling method, the effect of proximity-effect loss occurs near the air gap on winding surface temperature was considered. Additionally, the effect of anisotropic thermal conductivity in a winding block on the winding surface temperature was considered. In this study the first step is the measurement of the winding surface temperature distribution of an experimental dummy inductor that imitates proximity loss occurring locally near an air gap in order to confirm the influence of proximity loss on the winding surface temperature distribution. Next, we conducted a numerical simulation of the experimental dummy inductor winding surface temperature.
As a key point in the numerical modeling, the significance of considering the influence of the proximity-effect loss and the anisotropic thermal conductivity on the winding surface temperature was demonstrated experimentally and numerically. Less
|
Research Products
(9 results)
