2012 Fiscal Year Final Research Report
Creation of printable paper electronics by control of microstructure
| Project/Area Number |
22380092
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (B)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
Wood science
|
|---|
| Research Institution | University of Tsukuba (2012)
The University of Tokyo (2010-2011) |
|---|
Principal Investigator |
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
SATO Toshifumi 東京工芸大学, 工学部, 教授 (00308339)
ISOGAI Akira 東京大学, 大学院・農学生命科学研究科, 教授 (40191879)
|
|---|
| Project Period (FY) |
2010 – 2012
|
| Keywords | パルプ・紙 / エレクトロニクス / センサー |
|---|
| Research Abstract |
This research aims at efficient utilization of biomaterials and efficient electronics manufacturing. No electroconductivity was obtained with silver nano-ink lines printed by ink jet on non-coated paper because of breakage of the line due to falling into surface pores of paper. To solve this problem, a sheet of paper was immersed in a fluorinated solution and hydrophobized. This process prevented ensured the line continuity and electroconductivity. In application, paper-based medical check-up sensor to measure the concentration of blood sugar was tried to be fabricated. Several elemental technologies such as sensor paper from a cotton linter pulp, hydrophobic barrier of a micro-channel from a Ultra-Violet curable ink, electrodes from an electroconductive polymer ink, and glucosidase fixation on the electrode fabricated the sensor device successfully all by ink jet printing.
|
Research Products
(53 results)
