• Search Research Projects
  • Search Researchers
  • How to Use
  1. Back to project page

1995 Fiscal Year Final Research Report Summary

A Developmental Study for Occlusal Diagnosis System in Reference to Intercuspal Position

Research Project

Project/Area Number 06454559
Research Category

Grant-in-Aid for General Scientific Research (B)

Allocation TypeSingle-year Grants
Research Field 補綴理工系歯学
Research InstitutionKanagawa Dental College

Principal Investigator

AOKI Hideo  Kanagawa Dental College, Dentistry, Professor, 歯学部, 教授 (60084761)

Co-Investigator(Kenkyū-buntansha) INO Satoshi  Kanagawa Dental College, Dentistry, Assistant, 歯学部, 助手 (80257295)
KIMOTO Katsuhiko  Kanagawa Dental College, Dentistry, Assistant, 歯学部, 助手 (70205011)
ENDO Yukari  Kanagawa Dental College, Dentistry, Assistant, 歯学部, 助手 (70160405)
TAMAKI Katsushi  Kanagawa Dental College, Dentistry, Lecture, 歯学部, 講師 (00155243)
Project Period (FY) 1994 – 1995
KeywordsIntercuspal Position / Sirognathograph High Resolution Type / Computerized Axiograph System / mandibular and condylar movements / 切歯点および顆顎点
Research Abstract

The pertinent informations obtained for functional evaluation of the mnadibular and condylar movements are not only useful for examination and diagnosis of stomatognathic physiology and dysfunction but also applicabable to the construction of prosthetic appliances. Therefore, our department has been conducted in this primary subject during past years and these studies were supported by Grant-in-Aids from Ministry of Education, Science and Culture of Japan as in the following manner ; 1 : 1987-1988 (General Study B) Subject No.62480399,2 : 1990-1991 (General Study C) Subject No.02670879,3 : 1989 (Promotion Study A), Subject No.01771683,4 : 1993 (Promotion Study A) Subject No.05771744.
Present study is a continued research project from above subjects and it's objective is to clarify the correlation of informations from the Sirognathograph Analyzing System for anterior guidance, whereas CADIAX for posterior guidance resulting from mandibular and condylar movements. Consequently, three majo … More r studies were conducted as follows.
1. Developement of SGG Analyzing System with HR type.
Previous system III could be displayd tooth gliding surfaces in three dimensionally, but some distortions were also occured due to the characteristics of magnet attached to subjects lower incisors. Pilot study proved that a new type HR showed better stability and improved sensor frame in order to reduce the distortions on the tooth gliding surfaces.
2. Fundamental study of CADIAX system.
CADIAX makes it possible record the three dimentional movements of condyles which contribute to the objective assesment for functional diagnosis in stomatognathic system. However, there were practically no informations on the measurement accuracy of the computerized Axiograph related to CADIAX system.
Our experiments conclude 1 : Measurement accuracy of the electronic flag varied depending on its site and its values were recouded approximately within 3mm. 2 : Measurement accuracy of the electronic stylus was homogenous regardless of the degree of contraction within 0.07mm.
3 : Establishment of Occlusal Diagnosis System.
Present study made possible to connect the application of Sirognathograph Analyzing System and as anterior guidance information, and CADIAX system as posterior guidance one. Less

  • Research Products

    (8 results)

All Other

All Publications (8 results)

  • [Publications] 玉置 勝司: "歯牙接触滑走曲面と咀嚼運動経路に関する三次元的表示法の検討" 日本補綴歯科学会雑誌. 39. 280-284 (1995)

    • Description
      「研究成果報告書概要(和文)」より
  • [Publications] 木本 克彦: "咀嚼運動における咬頭嵌合位付近経路に関する研究" 日本補綴歯科学会雑誌. 39. 579-589 (1995)

    • Description
      「研究成果報告書概要(和文)」より
  • [Publications] Satoshi Ino: "An Experimental Study on the Measurrement Accuracy of the Computerizes Axiography" The Bulletin of Kanagawa Dental College. 23. 93-97 (1995)

    • Description
      「研究成果報告書概要(和文)」より
  • [Publications] Yukari Endo: "Recording Accuracy of Tooth Gliding Surfaces Using Sirognathograph Analyzing System III" The Bulletin of Kanagawa Dental College. 23. 99-100 (1995)

    • Description
      「研究成果報告書概要(和文)」より
  • [Publications] Katsushi Tamaki: "A Three Dimentional Displaying Method for Tooth Grinding Curved Suefaces and Pathways during Chewing Movements" The Journal of the Japan Prosthodontic Society. 39. 280-284 (1995)

    • Description
      「研究成果報告書概要(欧文)」より
  • [Publications] Katsuhiko Kimoto: "A Study on Pathway in Area of Intercuspal Position during Chewing Movements" The Journal of the Japan Prosthodontic Society. 39. 579-589 (1995)

    • Description
      「研究成果報告書概要(欧文)」より
  • [Publications] Satoshi Ino: "An Experimental Study on the Measurrement Accuracy of the Computerized Axiography" The Bulletin of Kanagawa Dental College. 23. 93-97 (1995)

    • Description
      「研究成果報告書概要(欧文)」より
  • [Publications] Yukari Endo: "Recording Accuracy of Tooth Gliding Surfaces Using Sirognathograph Analyzing System III" The Bulletin of Kanagawa Dental College. 23. 99-100 (1995)

    • Description
      「研究成果報告書概要(欧文)」より

URL: 

Published: 1997-03-04  

Information User Guide FAQ News Terms of Use Attribution of KAKENHI

Powered by NII kakenhi