1999 Fiscal Year Final Research Report Summary
Analysis of Chemisorption of the Adhesive Monomer on Alloy Surface
| Project/Area Number |
09672003
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
補綴理工系歯学
|
|---|
| Research Institution | Health Sciences University of Hokkaido |
|---|
Principal Investigator |
OHNO Hiroki Health Sciences University of Hokkaido, School of Dentistry, Professor, 歯学部, 教授 (70018430)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
ENDO Kazuhiko Health Sciences University of Hokkaido, School of Dentistry, Assoc. Professor, 歯学部, 助教授 (70168821)
|
|---|
| Project Period (FY) |
1997 – 1999
|
| Keywords | Adhesive monomer / Chemisorption / Quartz Crytal Micro-balance(QCM) / 4-META / Chelation / High-temperature Oxidation |
|---|
| Research Abstract |
Monomers such as 4-META, 4-AET, MAC-10, MDP, VBATDT, and M1OPS have been developed as adhesive monomers. The chemical bond between adhesive monomers and metal surfaces has not been fully elucidated. In the present study, evidence of the chemical bond of 4-META with metals was shown experimentally. The chemical bond of 4-META with metals was investigated by three experiments, a Quartz Crystal Micro-balance (QCM) method, an immersion test, and Laser-Raman spectroscopy. The frequency changes of the QCM can be converted to the weight of a mass deposited on the surface. The QCM measurement was shown that tin and copper were dissolved in the MMA solution containing 4-META. Raman shifts derived from the acid anhydride of 4-META at 1,850 and 1780 cmィイD2-1ィエD2 disappeared in the mixed solution, resulting in the formation of chelates or ionic compounds between the 4-META and tin.
By high-temperature oxidation and subsequent pickling, a reliable bend between resin and a precious metal alloy can be obtained through a combination of the following three effects: strengthening of the mechanical bond due to penetration of resin into the pores of the sponge-like structure on the alloy surface; strengthening of the chemical bond due to the application of 4-META and/or thiophosphate-type primer on the gold-rich surface; and reduction of stress due to polymerization shrinkage of resin with the soft sponge-like structure.
|
