2007 Fiscal Year Final Research Report Summary
Fabrication of photonic crystal by micro-molding using a mold of photostrictive element PLZT
Project/Area Number |
18560114
|
Research Category |
Grant-in-Aid for Scientific Research (C)
|
Allocation Type | Single-year Grants |
Section | 一般 |
Research Field |
Production engineering/Processing studies
|
Research Institution | Nihon University |
Principal Investigator |
SHIRAI Kenji Nihon University, College of Engineering, Professor (50256814)
|
Co-Investigator(Kenkyū-buntansha) |
YOSHIKAWA Yoshio Nihon University, College of Engineering, Professor (00059932)
KOBAYASHI Yoshikazu Nihon University, College of Engineering, Assistant Professor (60277390)
|
Project Period (FY) |
2006 – 2007
|
Keywords | Die and mold technology / Photonic crystal / Micro molding |
Research Abstract |
The purpose of this study is to fabricate the photonic crystal easily. This study proposes a micro-parts molding system using a die which can be transformed to any shape. This system combines imprinting technology with precision dies, realizing inexpensive mass production of micro plastic parts. The fundamental principle of the system is as follows. First, photostrictive element PLZT ceramics whose shapes can be changed using ultraviolet ray are used for die. The irradiation range of the ultraviolet ray is adjusted using a mask so that the die can be changed to any desired shape. Next, the die is filled with photopolymerizing polymer and closed in the glass plate. Ultraviolet ray is then irradiated on the die to mold the part. In this development, first a measuring device was developed in order to verify the characteristics of the PLZT ceramics. The transition of the transformation and the transformation response time of the PLZT ceramics while ultraviolet ray was irradiated were also measured. As a result, it is clear that the displacement of PUT surface is a sub-um level and the shape on the PLZT surface does not become shape of the mask.
|
Research Products
(28 results)
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
[Presentation] 微小物体の3次元形状再構成2008
Author(s)
原 靖彦
Organizer
2008年度精密工学会春季大会学術講演会
Place of Presentation
明治大学生田キャンパス
Year and Date
20080300
Description
「研究成果報告書概要(和文)」より
-
-
-
-
-
-
-
-
-