2007 Fiscal Year Final Research Report Summary
Development of metal sheet denture plate with a CAD/CAM system
| Project/Area Number |
18592114
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Single-year Grants |
|---|
| Section | 一般 |
|---|
| Research Field |
補綴理工系歯学
|
|---|
| Research Institution | Tokyo Medical and Dental University |
|---|
Principal Investigator |
MOTOMURA Kazuo Tokyo Medical and Dental University, Graduate School, Research Associate (60272598)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
NAKAMURA Hideo Tokyo Medical and Dental University, Graduate School, Research Associate (60172425)
NAKAMURA Tamotsu Shizuoka University, Faculty of engineering, Professor (70023322)
TANAKA Shigekazu Shizuoka University, Faculty of engineering, Assistant Professor (60197423)
|
|---|
| Project Period (FY) |
2006 – 2007
|
| Keywords | titanium / CAD / CAM / denture plate / incremental forming / the aging society |
|---|
| Research Abstract |
A flexible process for pure titanium denture plate using incremental forming technology is being developed. Denture plate is a important dental prosthetic component of complete denture with the aging society. In this research, incremental sheet metal stretch forming was applied to fabrication of pure titanium denture plates. This process, however, posed difficult problems about poor seizure resistance. In order to improve the surface quality, anodic oxide film was tested. Although the oxide film showed good seizure resistance, reproducible sliding marks were produced in a certain region. The effect of the feed rate of forming stylus and the slope of surface on the roughness was investigated systematically. The excessive feed rate increased the roughness because of deep tool marks. The small feed rate increased the roughness due to the severe slidingcontact with tool. The results confirmed the existence of optimum condition in which the roughness was minimized. But we can change the system that improvement of geometrical accuracy for titanium denture plate, other input interface of scanning from dental models.
|
Research Products
(7 results)
