2013 Fiscal Year Final Research Report
Research on the visualization of injection process in complex shaped molding and the suppression technology of polymer degradation
| Project/Area Number |
23560146
|
|---|
| Research Category |
Grant-in-Aid for Scientific Research (C)
|
| Allocation Type | Multi-year Fund |
|---|
| Section | 一般 |
|---|
| Research Field |
Production engineering/Processing studies
|
|---|
| Research Institution | Gunma Prefectural Industrial Technology Center |
|---|
Principal Investigator |
FUKUSHIMA YOSHIO 群馬県立産業技術センター, その他部局等, 研究員 (70310232)
|
|---|
| Co-Investigator(Kenkyū-buntansha) |
SUZUKI Takashi 群馬県立産業技術センター, 研究調整官 (40196837)
KUROIWA Hiroki 群馬県立産業技術センター, 独立研究員 (10553480)
KOMATSU Hidekazu 群馬県立産業技術センター, 独立研究員 (20469886)
MOTEGI Yukinobu 群馬県立産業技術センター, 独立研究員 (20552558)
TAKIGAMI Syouji 群馬大学, 准教授 (70143203)
|
|---|
| Project Period (FY) |
2011 – 2013
|
| Keywords | 射出成形 |
|---|
| Research Abstract |
Various approaches to solve the problem of molding defects like the warpage, the short-shot, and the burn marks have been investigated. In order to observe transition phenomena in the polymer injection, determination of outgas composition and visualization of inside situation in injection process were carried out in this work. In addition, rationalized gas monitoring method by utilizing sensor device was also examined to realize real time monitoring at the actual shot. It was successfully obtained that key chemical reactions in regard with appearance of burn mark by taking consideration into conditions which influenced the composition change of outgas. Finally basic knowledge to suppress molding defects was also discussed.
|
-
-
-
[Presentation]2014
Author(s)
鈴木崇,福島祥夫,黒岩広樹,恩田絋樹,小松秀和
Organizer
群馬県分析研究会
Place of Presentation
前橋
Year and Date
20140000
-
-
[Presentation]2013
Author(s)
T.Suda, H.Kuroiwa, Y.Fukushima, T.Suzuki, F.Takeuti
Organizer
The 7th International Conference on Leading Edge Manufacturing in 21st Century LEM21 in Matsushima
Place of Presentation
松島
Year and Date
20130000
-
-
[Presentation]2012
Author(s)
福島祥夫,鈴木崇,黒岩広樹,小松秀和
Organizer
成形加工シンポジア
Place of Presentation
名古屋
Year and Date
20120000
-
-
